OMAP: DSS2: HDMI: make set_timing saner

Currently the set_timings code for hdmi is quite strange. The display is
disabled in hdmi_omap4_panel.c before setting timings, and enabled in
hdmi.c after setting the timings. Furthermore, the timings were not
permanent, and disabling and enabling the display would lose them.

This patch makes the set_timings handling a bit better.

Cc: Mythri P K <mythripk@ti.com>
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@ti.com>

drivers/video/omap2/dss/hdmi.c

@@ -571,11 +571,20 @@ void omapdss_hdmi_display_set_timing(struct omap_dss_device *dssdev)
 	struct hdmi_cm cm;
 
 	hdmi.custom_set = 1;
+
 	cm = hdmi_get_code(&dssdev->panel.timings);
 	hdmi.code = cm.code;
 	hdmi.mode = cm.mode;
-	omapdss_hdmi_display_enable(dssdev);
-	hdmi.custom_set = 0;
+
+	if (dssdev->state == OMAP_DSS_DISPLAY_ACTIVE) {
+		int r;
+
+		hdmi_power_off(dssdev);
+
+		r = hdmi_power_on(dssdev);
+		if (r)
+			DSSERR("failed to power on device\n");
+	}
 }
 
 int omapdss_hdmi_display_enable(struct omap_dss_device *dssdev)

drivers/video/omap2/dss/hdmi_panel.c

@@ -161,12 +161,7 @@ static void hdmi_set_timings(struct omap_dss_device *dssdev,
 	mutex_lock(&hdmi.hdmi_lock);
 
 	dssdev->panel.timings = *timings;
-
-	if (dssdev->state == OMAP_DSS_DISPLAY_ACTIVE) {
-		/* turn the hdmi off and on to get new timings to use */
-		omapdss_hdmi_display_disable(dssdev);
-		omapdss_hdmi_display_set_timing(dssdev);
-	}
+	omapdss_hdmi_display_set_timing(dssdev);
 
 	mutex_unlock(&hdmi.hdmi_lock);
 }