sh_eth: convert pr_*() to netdev_*() calls

Convert pr_*() to netdev_*() calls as the latter provide info on a device.
Suggested-by: NJoe Perches <joe@perches.com>
Signed-off-by: NSergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/ethernet/renesas/sh_eth.c

@@ -400,7 +400,8 @@ static void sh_eth_select_mii(struct net_device *ndev)
 		value = 0x0;
 		break;
 	default:
-		pr_warn("PHY interface mode was not setup. Set to MII.\n");
+		netdev_warn(ndev,
+			    "PHY interface mode was not setup. Set to MII.\n");
 		value = 0x1;
 		break;
 	}
@@ -854,7 +855,7 @@ static int sh_eth_check_reset(struct net_device *ndev)
 		cnt--;
 	}
 	if (cnt <= 0) {
-		pr_err("Device reset failed\n");
+		netdev_err(ndev, "Device reset failed\n");
 		ret = -ETIMEDOUT;
 	}
 	return ret;
@@ -2924,8 +2925,8 @@ static int sh_eth_drv_probe(struct platform_device *pdev)
 	}
 
 	/* print device information */
-	pr_info("Base address at 0x%x, %pM, IRQ %d.\n",
-		(u32)ndev->base_addr, ndev->dev_addr, ndev->irq);
+	netdev_info(ndev, "Base address at 0x%x, %pM, IRQ %d.\n",
+		    (u32)ndev->base_addr, ndev->dev_addr, ndev->irq);
 
 	platform_set_drvdata(pdev, ndev);