提交 f40739fa 编写于 作者: J Jon Hunter 提交者: Tony Lindgren

ARM: dts: OMAP2+: Simplify NAND support

Commit 8c8a7771 (ARM: OMAP2+: Add function to read GPMC settings from
device-tree) added a device-tree property "gpmc,device-nand" to indicate
is the GPMC child device is NAND. This commit should have updated the
GPMC NAND documentation (Documentation/devicetree/bindings/mtd/gpmc-nand.txt)
to list the property "gpmc,device-nand" as a required property and also
updated the example. However, this property is redundant and not needed
because the GPMC child device node for NAND is called "nand". Therefore,
remove this property.
Signed-off-by: NJon Hunter <jon-hunter@ti.com>
Signed-off-by: NTony Lindgren <tony@atomide.com>
上级 496c8a0b
......@@ -95,7 +95,6 @@ GPMC chip-select settings properties for child nodes. All are optional.
- gpmc,burst-wrap Enables wrap bursting
- gpmc,burst-read Enables read page/burst mode
- gpmc,burst-write Enables write page/burst mode
- gpmc,device-nand Device is NAND
- gpmc,device-width Total width of device(s) connected to a GPMC
chip-select in bytes. The GPMC supports 8-bit
and 16-bit devices and so this property must be
......
......@@ -105,7 +105,6 @@
nand-bus-width = <8>;
ti,nand-ecc-opt = "sw";
gpmc,device-nand;
gpmc,cs-on-ns = <0>;
gpmc,cs-rd-off-ns = <36>;
gpmc,cs-wr-off-ns = <36>;
......
......@@ -102,8 +102,6 @@ int gpmc_nand_init(struct omap_nand_platform_data *gpmc_nand_data,
if (gpmc_nand_data->of_node) {
gpmc_read_settings_dt(gpmc_nand_data->of_node, &s);
} else {
s.device_nand = true;
/* Enable RD PIN Monitoring Reg */
if (gpmc_nand_data->dev_ready) {
s.wait_on_read = true;
......@@ -111,6 +109,8 @@ int gpmc_nand_init(struct omap_nand_platform_data *gpmc_nand_data,
}
}
s.device_nand = true;
if (gpmc_nand_data->devsize == NAND_BUSWIDTH_16)
s.device_width = GPMC_DEVWIDTH_16BIT;
else
......
......@@ -1245,7 +1245,6 @@ void gpmc_read_settings_dt(struct device_node *np, struct gpmc_settings *p)
p->sync_read = of_property_read_bool(np, "gpmc,sync-read");
p->sync_write = of_property_read_bool(np, "gpmc,sync-write");
p->device_nand = of_property_read_bool(np, "gpmc,device-nand");
of_property_read_u32(np, "gpmc,device-width", &p->device_width);
of_property_read_u32(np, "gpmc,mux-add-data", &p->mux_add_data);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册