提交 f05feded 编写于 作者: V Viresh Kumar

PM / OPP: dt-bindings: Rename "required-opp" as "required-opps"

This property can contain more than one phandle and it must be named
"required-opps" instead.
Suggested-by: NStephen Boyd <sboyd@kernel.org>
Signed-off-by: NViresh Kumar <viresh.kumar@linaro.org>
Reviewed-by: NUlf Hansson <ulf.hansson@linaro.org>
Reviewed-by: NRob Herring <robh@kernel.org>
上级 495ac33a
......@@ -159,7 +159,7 @@ Optional properties:
- status: Marks the node enabled/disabled.
- required-opp: This contains phandle to an OPP node in another device's OPP
- required-opps: This contains phandle to an OPP node in another device's OPP
table. It may contain an array of phandles, where each phandle points to an
OPP of a different device. It should not contain multiple phandles to the OPP
nodes in the same OPP table. This specifies the minimum required OPP of the
......
......@@ -127,7 +127,7 @@ inside a PM domain with index 0 of a power controller represented by a node
with the label "power".
Optional properties:
- required-opp: This contains phandle to an OPP node in another device's OPP
- required-opps: This contains phandle to an OPP node in another device's OPP
table. It may contain an array of phandles, where each phandle points to an
OPP of a different device. It should not contain multiple phandles to the OPP
nodes in the same OPP table. This specifies the minimum required OPP of the
......@@ -175,14 +175,14 @@ Example:
compatible = "foo,i-leak-current";
reg = <0x12350000 0x1000>;
power-domains = <&power 0>;
required-opp = <&domain0_opp_0>;
required-opps = <&domain0_opp_0>;
};
leaky-device1@12350000 {
compatible = "foo,i-leak-current";
reg = <0x12350000 0x1000>;
power-domains = <&power 1>;
required-opp = <&domain1_opp_1>;
required-opps = <&domain1_opp_1>;
};
[1]. Documentation/devicetree/bindings/power/domain-idle-state.txt
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册