ARM: Orion: Add arch support needed for I2C via DT.

The MV64XXX I2C driver needs a clock in order to calculate the baud
rate factors. So add an clk to the clk tree. Also add the base DT
properties for kirkwood devices.
Signed-off-by: NAndrew Lunn <andrew@lunn.ch>

Conflicts:
	arch/arm/mach-kirkwood/common.c

arch/arm/boot/dts/kirkwood.dtsi

@@ -82,5 +82,15 @@
 			/* set partition map and/or chip-delay in board dts */
 			status = "disabled";
 		};
+
+		i2c@11000 {
+			compatible = "marvell,mv64xxx-i2c";
+			reg = <0x11000 0x20>;
+			#address-cells = <1>;
+			#size-cells = <0>;
+			interrupts = <29>;
+			clock-frequency = <100000>;
+			status = "disabled";
+		};
 	};
 };

arch/arm/mach-kirkwood/board-dt.c

@@ -28,6 +28,8 @@ static struct of_device_id kirkwood_dt_match_table[] __initdata = {
 
 struct of_dev_auxdata kirkwood_auxdata_lookup[] __initdata = {
 	OF_DEV_AUXDATA("marvell,orion-spi", 0xf1010600, "orion_spi.0", NULL),
+	OF_DEV_AUXDATA("marvell,mv64xxx-i2c", 0xf1011000, "mv64xxx_i2c.0",
+		       NULL),
 	{},
 };
 

arch/arm/mach-kirkwood/common.c

@@ -17,6 +17,7 @@
 #include <linux/dma-mapping.h>
 #include <linux/clk-provider.h>
 #include <linux/spinlock.h>
+#include <linux/mv643xx_i2c.h>
 #include <net/dsa.h>
 #include <asm/page.h>
 #include <asm/timex.h>
@@ -276,6 +277,7 @@ void __init kirkwood_clk_init(void)
 	orion_clkdev_add("0", "pcie", pex0);
 	orion_clkdev_add("1", "pcie", pex1);
 	orion_clkdev_add(NULL, "kirkwood-i2s", audio);
+	orion_clkdev_add(NULL, MV64XXX_I2C_CTLR_NAME ".0", runit);
 
 	/* Marvell says runit is used by SPI, UART, NAND, TWSI, ...,
 	 * so should never be gated.

arch/arm/plat-orion/common.c

@@ -47,6 +47,7 @@ void __init orion_clkdev_init(struct clk *tclk)
 	orion_clkdev_add(NULL, MV643XX_ETH_NAME ".2", tclk);
 	orion_clkdev_add(NULL, MV643XX_ETH_NAME ".3", tclk);
 	orion_clkdev_add(NULL, "orion_wdt", tclk);
+	orion_clkdev_add(NULL, MV64XXX_I2C_CTLR_NAME ".0", tclk);
 }
 
 /* Fill in the resources structure and link it into the platform