提交 e8648e5e 编写于 作者: T Takashi Iwai

ALSA: hda - Ignore small negative LPIB delay correction

Sometimes the hardware reports LPIB being advanced than POSBUF.
When this happens, the driver adjusts to a positive value by adding
the buffer size.  Then the driver detects it as an error (greater than
the period size), and stops the LPIB delay account from this point
on.

When I took a close look at these conditions, the values shown are all
very small numbers, and it'd be better to just ignore these values
instead of discontinuing the LPIB delay correction.

In this patch, the driver checks a negative delay value and ignores if
it's a significantly small error.  Currently the threshold is set to
64 frames, but could be smaller.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
上级 4f7f67fb
......@@ -431,6 +431,8 @@ struct azx_dev {
struct timecounter azx_tc;
struct cyclecounter azx_cc;
int delay_negative_threshold;
#ifdef CONFIG_SND_HDA_DSP_LOADER
struct mutex dsp_mutex;
#endif
......@@ -2195,6 +2197,15 @@ static int azx_pcm_prepare(struct snd_pcm_substream *substream)
goto unlock;
}
/* when LPIB delay correction gives a small negative value,
* we ignore it; currently set the threshold statically to
* 64 frames
*/
if (runtime->period_size > 64)
azx_dev->delay_negative_threshold = -frames_to_bytes(runtime, 64);
else
azx_dev->delay_negative_threshold = 0;
/* wallclk has 24Mhz clock source */
azx_dev->period_wallclk = (((runtime->period_size * 24000) /
runtime->rate) * 1000);
......@@ -2447,8 +2458,12 @@ static unsigned int azx_get_position(struct azx *chip,
delay = pos - lpib_pos;
else
delay = lpib_pos - pos;
if (delay < 0)
delay += azx_dev->bufsize;
if (delay < 0) {
if (delay >= azx_dev->delay_negative_threshold)
delay = 0;
else
delay += azx_dev->bufsize;
}
if (delay >= azx_dev->period_bytes) {
snd_printk(KERN_WARNING SFX
"%s: Unstable LPIB (%d >= %d); "
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册