iwlwifi: use scan while idle

As idle is just a deep powersave mode for
the device, it will easily scan while idle
since that turns off powersave.

This reduces the number of commands sent
to the device when scanning.
Signed-off-by: NJohannes Berg <johannes.berg@intel.com>
Signed-off-by: NWey-Yi Guy <wey-yi.w.guy@intel.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

drivers/net/wireless/iwlwifi/iwl-mac80211.c

@@ -157,7 +157,8 @@ int iwlagn_mac_setup_register(struct iwl_priv *priv,
 	 */
 
 	hw->flags |= IEEE80211_HW_SUPPORTS_PS |
-		     IEEE80211_HW_SUPPORTS_DYNAMIC_PS;
+		     IEEE80211_HW_SUPPORTS_DYNAMIC_PS |
+		     IEEE80211_HW_SCAN_WHILE_IDLE;
 
 	if (hw_params(priv).sku & EEPROM_SKU_CAP_11N_ENABLE)
 		hw->flags |= IEEE80211_HW_SUPPORTS_DYNAMIC_SMPS |

drivers/net/wireless/iwlwifi/iwl-scan.c

@@ -806,8 +806,12 @@ static int iwlagn_request_scan(struct iwl_priv *priv, struct ieee80211_vif *vif)
 	rate_flags |= iwl_ant_idx_to_flags(priv->scan_tx_ant[band]);
 	scan->tx_cmd.rate_n_flags = iwl_hw_set_rate_n_flags(rate, rate_flags);
 
-	/* In power save mode use one chain, otherwise use all chains */
-	if (test_bit(STATUS_POWER_PMI, &priv->shrd->status)) {
+	/*
+	 * In power save mode while associated use one chain,
+	 * otherwise use all chains
+	 */
+	if (test_bit(STATUS_POWER_PMI, &priv->shrd->status) &&
+	    !(priv->hw->conf.flags & IEEE80211_CONF_IDLE)) {
 		/* rx_ant has been set to all valid chains previously */
 		active_chains = rx_ant &
 				((u8)(priv->chain_noise_data.active_chains));