netvsc: fix incorrect receive checksum offloading

The Hyper-V netvsc driver was looking at the incorrect status bits
in the checksum info. It was setting the receive checksum unnecessary
flag based on the IP header checksum being correct. The checksum
flag is skb is about TCP and UDP checksum status. Because of this
bug, any packet received with bad TCP checksum would be passed
up the stack and to the application causing data corruption.
The problem is reproducible via netcat and netem.

This had a side effect of not doing receive checksum offload
on IPv6. The driver was also also always doing checksum offload
independent of the checksum setting done via ethtool.
Signed-off-by: NStephen Hemminger <sthemmin@microsoft.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/hyperv/netvsc_drv.c

@@ -607,15 +607,18 @@ static struct sk_buff *netvsc_alloc_recv_skb(struct net_device *net,
 	       packet->total_data_buflen);
 
 	skb->protocol = eth_type_trans(skb, net);
-	if (csum_info) {
-		/* We only look at the IP checksum here.
-		 * Should we be dropping the packet if checksum
-		 * failed? How do we deal with other checksums - TCP/UDP?
-		 */
-		if (csum_info->receive.ip_checksum_succeeded)
+
+	/* skb is already created with CHECKSUM_NONE */
+	skb_checksum_none_assert(skb);
+
+	/*
+	 * In Linux, the IP checksum is always checked.
+	 * Do L4 checksum offload if enabled and present.
+	 */
+	if (csum_info && (net->features & NETIF_F_RXCSUM)) {
+		if (csum_info->receive.tcp_checksum_succeeded ||
+		    csum_info->receive.udp_checksum_succeeded)
 			skb->ip_summed = CHECKSUM_UNNECESSARY;
-		else
-			skb->ip_summed = CHECKSUM_NONE;
 	}
 
 	if (vlan_tci & VLAN_TAG_PRESENT)