ixgb: convert to new VLAN model

Based on a patch from Jesse Gross <jesse@nicira.com>

This switches the ixgb driver to use the new VLAN interfaces.
In doing this, it completes the work begun in
ae54496f allowing the use of
hardware VLAN insertion without having a VLAN group configured.

CC: Jesse Gross <jesse@nicira.com>
Signed-off-by: NEmil Tantilov <emil.s.tantilov@intel.com>
Tested-by: NJeff Pieper <jeffrey.e.pieper@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ixgb/ixgb.h

@@ -149,7 +149,7 @@ struct ixgb_desc_ring {
 
 struct ixgb_adapter {
 	struct timer_list watchdog_timer;
-	struct vlan_group *vlgrp;
+	unsigned long active_vlans[BITS_TO_LONGS(VLAN_N_VID)];
 	u32 bd_number;
 	u32 rx_buffer_len;
 	u32 part_num;

drivers/net/ixgb/ixgb_ethtool.c

@@ -706,6 +706,43 @@ ixgb_get_strings(struct net_device *netdev, u32 stringset, u8 *data)
 	}
 }
 
+static int ixgb_set_flags(struct net_device *netdev, u32 data)
+{
+	struct ixgb_adapter *adapter = netdev_priv(netdev);
+	bool need_reset;
+	int rc;
+
+	/*
+	 * Tx VLAN insertion does not work per HW design when Rx stripping is
+	 * disabled.  Disable txvlan when rxvlan is turned off, and enable
+	 * rxvlan when txvlan is turned on.
+	 */
+	if (!(data & ETH_FLAG_RXVLAN) &&
+	    (netdev->features & NETIF_F_HW_VLAN_TX))
+		data &= ~ETH_FLAG_TXVLAN;
+	else if (data & ETH_FLAG_TXVLAN)
+		data |= ETH_FLAG_RXVLAN;
+
+	need_reset = (data & ETH_FLAG_RXVLAN) !=
+		     (netdev->features & NETIF_F_HW_VLAN_RX);
+
+	rc = ethtool_op_set_flags(netdev, data, ETH_FLAG_RXVLAN |
+						ETH_FLAG_TXVLAN);
+	if (rc)
+		return rc;
+
+	if (need_reset) {
+		if (netif_running(netdev)) {
+			ixgb_down(adapter, true);
+			ixgb_up(adapter);
+			ixgb_set_speed_duplex(netdev);
+		} else
+			ixgb_reset(adapter);
+	}
+
+	return 0;
+}
+
 static const struct ethtool_ops ixgb_ethtool_ops = {
 	.get_settings = ixgb_get_settings,
 	.set_settings = ixgb_set_settings,
@@ -732,6 +769,8 @@ static const struct ethtool_ops ixgb_ethtool_ops = {
 	.phys_id = ixgb_phys_id,
 	.get_sset_count = ixgb_get_sset_count,
 	.get_ethtool_stats = ixgb_get_ethtool_stats,
+	.get_flags = ethtool_op_get_flags,
+	.set_flags = ixgb_set_flags,
 };
 
 void ixgb_set_ethtool_ops(struct net_device *netdev)

drivers/net/ixgb/ixgb_main.c

@@ -100,8 +100,6 @@ static void ixgb_tx_timeout_task(struct work_struct *work);
 
 static void ixgb_vlan_strip_enable(struct ixgb_adapter *adapter);
 static void ixgb_vlan_strip_disable(struct ixgb_adapter *adapter);
-static void ixgb_vlan_rx_register(struct net_device *netdev,
-                                  struct vlan_group *grp);
 static void ixgb_vlan_rx_add_vid(struct net_device *netdev, u16 vid);
 static void ixgb_vlan_rx_kill_vid(struct net_device *netdev, u16 vid);
 static void ixgb_restore_vlan(struct ixgb_adapter *adapter);
@@ -336,7 +334,6 @@ static const struct net_device_ops ixgb_netdev_ops = {
 	.ndo_set_mac_address	= ixgb_set_mac,
 	.ndo_change_mtu		= ixgb_change_mtu,
 	.ndo_tx_timeout		= ixgb_tx_timeout,
-	.ndo_vlan_rx_register	= ixgb_vlan_rx_register,
 	.ndo_vlan_rx_add_vid	= ixgb_vlan_rx_add_vid,
 	.ndo_vlan_rx_kill_vid	= ixgb_vlan_rx_kill_vid,
 #ifdef CONFIG_NET_POLL_CONTROLLER
@@ -1508,7 +1505,7 @@ ixgb_xmit_frame(struct sk_buff *skb, struct net_device *netdev)
                      DESC_NEEDED)))
 		return NETDEV_TX_BUSY;
 
-	if (adapter->vlgrp && vlan_tx_tag_present(skb)) {
+	if (vlan_tx_tag_present(skb)) {
 		tx_flags |= IXGB_TX_FLAGS_VLAN;
 		vlan_id = vlan_tx_tag_get(skb);
 	}
@@ -2049,12 +2046,11 @@ ixgb_clean_rx_irq(struct ixgb_adapter *adapter, int *work_done, int work_to_do)
 		ixgb_rx_checksum(adapter, rx_desc, skb);
 
 		skb->protocol = eth_type_trans(skb, netdev);
-		if (adapter->vlgrp && (status & IXGB_RX_DESC_STATUS_VP)) {
-			vlan_hwaccel_receive_skb(skb, adapter->vlgrp,
-			                        le16_to_cpu(rx_desc->special));
-		} else {
-			netif_receive_skb(skb);
-		}
+		if (status & IXGB_RX_DESC_STATUS_VP)
+			__vlan_hwaccel_put_tag(skb,
+					       le16_to_cpu(rx_desc->special));
+
+		netif_receive_skb(skb);
 
 rxdesc_done:
 		/* clean up descriptor, might be written over by hw */
@@ -2152,20 +2148,6 @@ ixgb_alloc_rx_buffers(struct ixgb_adapter *adapter, int cleaned_count)
 	}
 }
 
-/**
- * ixgb_vlan_rx_register - enables or disables vlan tagging/stripping.
- *
- * @param netdev network interface device structure
- * @param grp indicates to enable or disable tagging/stripping
- **/
-static void
-ixgb_vlan_rx_register(struct net_device *netdev, struct vlan_group *grp)
-{
-	struct ixgb_adapter *adapter = netdev_priv(netdev);
-
-	adapter->vlgrp = grp;
-}
-
 static void
 ixgb_vlan_strip_enable(struct ixgb_adapter *adapter)
 {
@@ -2200,6 +2182,7 @@ ixgb_vlan_rx_add_vid(struct net_device *netdev, u16 vid)
 	vfta = IXGB_READ_REG_ARRAY(&adapter->hw, VFTA, index);
 	vfta |= (1 << (vid & 0x1F));
 	ixgb_write_vfta(&adapter->hw, index, vfta);
+	set_bit(vid, adapter->active_vlans);
 }
 
 static void
@@ -2208,35 +2191,22 @@ ixgb_vlan_rx_kill_vid(struct net_device *netdev, u16 vid)
 	struct ixgb_adapter *adapter = netdev_priv(netdev);
 	u32 vfta, index;
 
-	ixgb_irq_disable(adapter);
-
-	vlan_group_set_device(adapter->vlgrp, vid, NULL);
-
-	/* don't enable interrupts unless we are UP */
-	if (adapter->netdev->flags & IFF_UP)
-		ixgb_irq_enable(adapter);
-
 	/* remove VID from filter table */
 
 	index = (vid >> 5) & 0x7F;
 	vfta = IXGB_READ_REG_ARRAY(&adapter->hw, VFTA, index);
 	vfta &= ~(1 << (vid & 0x1F));
 	ixgb_write_vfta(&adapter->hw, index, vfta);
+	clear_bit(vid, adapter->active_vlans);
 }
 
 static void
 ixgb_restore_vlan(struct ixgb_adapter *adapter)
 {
-	ixgb_vlan_rx_register(adapter->netdev, adapter->vlgrp);
-
-	if (adapter->vlgrp) {
-		u16 vid;
-		for (vid = 0; vid < VLAN_N_VID; vid++) {
-			if (!vlan_group_get_device(adapter->vlgrp, vid))
-				continue;
-			ixgb_vlan_rx_add_vid(adapter->netdev, vid);
-		}
-	}
+	u16 vid;
+
+	for_each_set_bit(vid, adapter->active_vlans, VLAN_N_VID)
+		ixgb_vlan_rx_add_vid(adapter->netdev, vid);
 }
 
 #ifdef CONFIG_NET_POLL_CONTROLLER