dt-bindings: add bindings for i2c-pca-platform

Signed-off-by: NChris Packham <chris.packham@alliedtelesis.co.nz>
Acked-by: NRob Herring <robh@kernel.org>
Signed-off-by: NWolfram Sang <wsa@the-dreams.de>

Documentation/devicetree/bindings/i2c/i2c-pca-platform.txt

+* NXP PCA PCA9564/PCA9665 I2C controller
+
+The PCA9564/PCA9665 serves as an interface between most standard
+parallel-bus microcontrollers/microprocessors and the serial I2C-bus
+and allows the parallel bus system to communicate bi-directionally
+with the I2C-bus.
+
+Required properties :
+
+ - reg : Offset and length of the register set for the device
+ - compatible : one of "nxp,pca9564" or "nxp,pca9665"
+
+Optional properties
+ - interrupts : the interrupt number
+ - interrupt-parent : the phandle for the interrupt controller.
+   If an interrupt is not specified polling will be used.
+ - reset-gpios : gpio specifier for gpio connected to RESET_N pin. As the line
+   is active low, it should be marked GPIO_ACTIVE_LOW.
+ - clock-frequency : I2C bus frequency.
+
+Example:
+	i2c0: i2c@80000 {
+		compatible = "nxp,pca9564";
+		#address-cells = <1>;
+		#size-cells = <0>;
+		reg = <0x80000 0x4>;
+		reset-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>;
+		clock-frequency = <100000>;
+	};