USB: UHCI: Remove PCI dependencies from uhci-hub

This patch is part of a series that extend the UHCI HCD to support
non-PCI host controllers.

uhci-hub.c contained two PCI vendor checks for silicon quirks. Move
these checks into uhci-hcd.c and use bits in uhci_hcd structure to
mark that we need to use the quirks.

This patch is followed by other patches that will remove PCI
dependencies from uhci-hcd.c as well.
Signed-off-by: NJan Andersson <jan@gaisler.com>
Acked-by: NAlan Stern <stern@rowland.harvard.edu>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>

drivers/usb/host/uhci-hcd.c

@@ -546,6 +546,17 @@ static int uhci_init(struct usb_hcd *hcd)
 	}
 	uhci->rh_numports = port;
 
+	/* Intel controllers report the OverCurrent bit active on.
+	 * VIA controllers report it active off, so we'll adjust the
+	 * bit value.  (It's not standardized in the UHCI spec.)
+	 */
+	if (to_pci_dev(uhci_dev(uhci))->vendor == PCI_VENDOR_ID_VIA)
+		uhci->oc_low = 1;
+
+	/* HP's server management chip requires a longer port reset delay. */
+	if (to_pci_dev(uhci_dev(uhci))->vendor == PCI_VENDOR_ID_HP)
+		uhci->wait_for_hp = 1;
+
 	/* Kick BIOS off this hardware and reset if the controller
 	 * isn't already safely quiescent.
 	 */

drivers/usb/host/uhci-hcd.h

@@ -415,6 +415,10 @@ struct uhci_hcd {
 
 	struct timer_list fsbr_timer;		/* For turning off FBSR */
 
+	/* Silicon quirks */
+	unsigned int oc_low:1;			/* OverCurrent bit active low */
+	unsigned int wait_for_hp:1;		/* Wait for HP port reset */
+
 	/* Support for port suspend/resume/reset */
 	unsigned long port_c_suspend;		/* Bit-arrays of ports */
 	unsigned long resuming_ports;

drivers/usb/host/uhci-hub.c

@@ -149,8 +149,7 @@ static void uhci_check_ports(struct uhci_hcd *uhci)
 
 				/* HP's server management chip requires
 				 * a longer delay. */
-				if (to_pci_dev(uhci_dev(uhci))->vendor ==
-						PCI_VENDOR_ID_HP)
+				if (uhci->wait_for_hp)
 					wait_for_HP(port_addr);
 
 				/* If the port was enabled before, turning
@@ -266,8 +265,7 @@ static int uhci_hub_control(struct usb_hcd *hcd, u16 typeReq, u16 wValue,
 		 * VIA controllers report it active off, so we'll adjust the
 		 * bit value.  (It's not standardized in the UHCI spec.)
 		 */
-		if (to_pci_dev(hcd->self.controller)->vendor ==
-				PCI_VENDOR_ID_VIA)
+		if (uhci->oc_low)
 			status ^= USBPORTSC_OC;
 
 		/* UHCI doesn't support C_RESET (always false) */