mtd: denali: use 8 bytes for READID command

The Denali NAND driver reads only 5 bytes of ID, but some Hynix and Samsung
have size parameters in the 6th byte.  As a result, the page and oob size
for a Hynix H27UAG8T2B were calculated incorrectly and the driver failed to
load.

The solution is to read 8 bytes of ID, as expected by the NAND framework.
Signed-off-by: NGraham Moore <grmoore@altera.com>
Signed-off-by: NBrian Norris <computersforpeace@gmail.com>

drivers/mtd/nand/denali.c

@@ -473,7 +473,7 @@ static void detect_partition_feature(struct denali_nand_info *denali)
 static uint16_t denali_nand_timing_set(struct denali_nand_info *denali)
 {
 	uint16_t status = PASS;
-	uint32_t id_bytes[5], addr;
+	uint32_t id_bytes[8], addr;
 	uint8_t i, maf_id, device_id;
 
 	dev_dbg(denali->dev,
@@ -488,7 +488,7 @@ static uint16_t denali_nand_timing_set(struct denali_nand_info *denali)
 	addr = (uint32_t)MODE_11 | BANK(denali->flash_bank);
 	index_addr(denali, (uint32_t)addr | 0, 0x90);
 	index_addr(denali, (uint32_t)addr | 1, 0);
-	for (i = 0; i < 5; i++)
+	for (i = 0; i < 8; i++)
 		index_addr_read_data(denali, addr | 2, &id_bytes[i]);
 	maf_id = id_bytes[0];
 	device_id = id_bytes[1];
@@ -1276,7 +1276,7 @@ static void denali_cmdfunc(struct mtd_info *mtd, unsigned int cmd, int col,
 		addr = (uint32_t)MODE_11 | BANK(denali->flash_bank);
 		index_addr(denali, (uint32_t)addr | 0, 0x90);
 		index_addr(denali, (uint32_t)addr | 1, 0);
-		for (i = 0; i < 5; i++) {
+		for (i = 0; i < 8; i++) {
 			index_addr_read_data(denali,
 						(uint32_t)addr | 2,
 						&id);