arm: mach-mx3: use IMX_GPIO_NR instead of hard-coded values

The latter are error-prone because the bank number is one less than one
would read in the documentation.
Signed-off-by: NWolfram Sang <w.sang@pengutronix.de>
Acked-by: NEric Benard <eric@eukrea.com>
Cc: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: NSascha Hauer <s.hauer@pengutronix.de>

arch/arm/mach-mx3/eukrea_mbimxsd-baseboard.c

@@ -165,8 +165,8 @@ static iomux_v3_cfg_t eukrea_mbimxsd_pads[] = {
 	MX35_PAD_SD1_DATA3__ESDHC1_DAT3,
 };
 
-#define GPIO_LED1	(2 * 32 + 29)
-#define GPIO_SWITCH1	(2 * 32 + 25)
+#define GPIO_LED1	IMX_GPIO_NR(3, 29)
+#define GPIO_SWITCH1	IMX_GPIO_NR(3, 25)
 #define GPIO_LCDPWR	(4)
 
 static void eukrea_mbimxsd_lcd_power_set(struct plat_lcd_data *pd,

arch/arm/mach-mx3/mach-cpuimx35.c

@@ -60,7 +60,7 @@ static struct tsc2007_platform_data tsc2007_info = {
 	.x_plate_ohms		= 180,
 };
 
-#define TSC2007_IRQGPIO		(2 * 32 + 2)
+#define TSC2007_IRQGPIO		IMX_GPIO_NR(3, 2)
 static struct i2c_board_info eukrea_cpuimx35_i2c_devices[] = {
 	{
 		I2C_BOARD_INFO("pcf8563", 0x51),

arch/arm/mach-mx3/mach-pcm043.c

@@ -219,9 +219,9 @@ static iomux_v3_cfg_t pcm043_pads[] = {
 	MX35_PAD_SD1_DATA3__ESDHC1_DAT3,
 };
 
-#define AC97_GPIO_TXFS	(1 * 32 + 31)
-#define AC97_GPIO_TXD	(1 * 32 + 28)
-#define AC97_GPIO_RESET	(1 * 32 + 0)
+#define AC97_GPIO_TXFS	IMX_GPIO_NR(2, 31)
+#define AC97_GPIO_TXD	IMX_GPIO_NR(2, 28)
+#define AC97_GPIO_RESET	IMX_GPIO_NR(2, 0)
 
 static void pcm043_ac97_warm_reset(struct snd_ac97 *ac97)
 {