提交 d1ee4335 编写于 作者: H H. Peter Anvin

x86, trampoline: Use the unified trampoline setup for ACPI wakeup

Use the unified trampoline allocation setup to allocate and install
the ACPI wakeup code in low memory.
Signed-off-by: NH. Peter Anvin <hpa@linux.intel.com>
LKML-Reference: <4D5DFBE4.7090104@intel.com>
Cc: Rafael J. Wysocki <rjw@sisk.pl>
Cc: Matthieu Castet <castet.matthieu@free.fr>
Cc: Stephen Rothwell <sfr@canb.auug.org.au>
上级 4822b7fc
......@@ -29,6 +29,7 @@
#include <asm/processor.h>
#include <asm/mmu.h>
#include <asm/mpspec.h>
#include <asm/trampoline.h>
#define COMPILER_DEPENDENT_INT64 long long
#define COMPILER_DEPENDENT_UINT64 unsigned long long
......@@ -116,7 +117,8 @@ static inline void acpi_disable_pci(void)
extern int acpi_save_state_mem(void);
extern void acpi_restore_state_mem(void);
extern unsigned long acpi_wakeup_address;
extern const unsigned char acpi_wakeup_code[];
#define acpi_wakeup_address (__pa(TRAMPOLINE_SYM(acpi_wakeup_code)))
/* early initialization routine */
extern void acpi_reserve_wakeup_memory(void);
......
......@@ -3,25 +3,36 @@
#ifndef __ASSEMBLY__
#ifdef CONFIG_X86_TRAMPOLINE
#include <linux/types.h>
#include <asm/io.h>
/*
* Trampoline 80x86 program as an array.
* Trampoline 80x86 program as an array. These are in the init rodata
* segment, but that's okay, because we only care about the relative
* addresses of the symbols.
*/
extern const unsigned char trampoline_data [];
extern const unsigned char trampoline_end [];
extern unsigned char *trampoline_base;
extern const unsigned char x86_trampoline_start [];
extern const unsigned char x86_trampoline_end [];
extern unsigned char *x86_trampoline_base;
extern unsigned long init_rsp;
extern unsigned long initial_code;
extern unsigned long initial_gs;
#define TRAMPOLINE_SIZE roundup(trampoline_end - trampoline_data, PAGE_SIZE)
extern void __init setup_trampolines(void);
extern const unsigned char trampoline_data[];
extern const unsigned char trampoline_status[];
#define TRAMPOLINE_SYM(x) \
((void *)(x86_trampoline_base + \
((const unsigned char *)(x) - x86_trampoline_start)))
extern unsigned long setup_trampoline(void);
extern void __init reserve_trampoline_memory(void);
#else
static inline void reserve_trampoline_memory(void) {}
#endif /* CONFIG_X86_TRAMPOLINE */
/* Address of the SMP trampoline */
static inline unsigned long trampoline_address(void)
{
return virt_to_phys(TRAMPOLINE_SYM(trampoline_data));
}
#endif /* __ASSEMBLY__ */
......
......@@ -6,11 +6,17 @@
#include <asm/page_types.h>
#include <asm/pgtable_types.h>
#include <asm/processor-flags.h>
#include "wakeup.h"
.code16
.section ".header", "a"
.section ".jump", "ax"
.globl _start
_start:
cli
jmp wakeup_code
/* This should match the structure in wakeup.h */
.section ".header", "a"
.globl wakeup_header
wakeup_header:
video_mode: .short 0 /* Video mode number */
......@@ -30,14 +36,11 @@ wakeup_jmp: .byte 0xea /* ljmpw */
wakeup_jmp_off: .word 3f
wakeup_jmp_seg: .word 0
wakeup_gdt: .quad 0, 0, 0
signature: .long 0x51ee1111
signature: .long WAKEUP_HEADER_SIGNATURE
.text
.globl _start
.code16
wakeup_code:
_start:
cli
cld
/* Apparently some dimwit BIOS programmers don't know how to
......@@ -77,12 +80,12 @@ _start:
/* Check header signature... */
movl signature, %eax
cmpl $0x51ee1111, %eax
cmpl $WAKEUP_HEADER_SIGNATURE, %eax
jne bogus_real_magic
/* Check we really have everything... */
movl end_signature, %eax
cmpl $0x65a22c82, %eax
cmpl $WAKEUP_END_SIGNATURE, %eax
jne bogus_real_magic
/* Call the C code */
......@@ -147,3 +150,7 @@ wakeup_heap:
wakeup_stack:
.space 2048
wakeup_stack_end:
.section ".signature","a"
end_signature:
.long WAKEUP_END_SIGNATURE
......@@ -35,7 +35,8 @@ struct wakeup_header {
extern struct wakeup_header wakeup_header;
#endif
#define HEADER_OFFSET 0x3f00
#define WAKEUP_SIZE 0x4000
#define WAKEUP_HEADER_OFFSET 8
#define WAKEUP_HEADER_SIGNATURE 0x51ee1111
#define WAKEUP_END_SIGNATURE 0x65a22c82
#endif /* ARCH_X86_KERNEL_ACPI_RM_WAKEUP_H */
......@@ -13,9 +13,19 @@ ENTRY(_start)
SECTIONS
{
. = 0;
.jump : {
*(.jump)
} = 0x90909090
. = WAKEUP_HEADER_OFFSET;
.header : {
*(.header)
}
. = ALIGN(16);
.text : {
*(.text*)
}
} = 0x90909090
. = ALIGN(16);
.rodata : {
......@@ -33,11 +43,6 @@ SECTIONS
*(.data*)
}
.signature : {
end_signature = .;
LONG(0x65a22c82)
}
. = ALIGN(16);
.bss : {
__bss_start = .;
......@@ -45,20 +50,13 @@ SECTIONS
__bss_end = .;
}
. = HEADER_OFFSET;
.header : {
*(.header)
.signature : {
*(.signature)
}
. = ALIGN(16);
_end = .;
/DISCARD/ : {
*(.note*)
}
/*
* The ASSERT() sink to . is intentional, for binutils 2.14 compatibility:
*/
. = ASSERT(_end <= WAKEUP_SIZE, "Wakeup too big!");
}
......@@ -18,12 +18,8 @@
#include "realmode/wakeup.h"
#include "sleep.h"
unsigned long acpi_wakeup_address;
unsigned long acpi_realmode_flags;
/* address in low memory of the wakeup routine. */
static unsigned long acpi_realmode;
#if defined(CONFIG_SMP) && defined(CONFIG_64BIT)
static char temp_stack[4096];
#endif
......@@ -33,22 +29,17 @@ static char temp_stack[4096];
*
* Create an identity mapped page table and copy the wakeup routine to
* low memory.
*
* Note that this is too late to change acpi_wakeup_address.
*/
int acpi_save_state_mem(void)
{
struct wakeup_header *header;
/* address in low memory of the wakeup routine. */
char *acpi_realmode;
if (!acpi_realmode) {
printk(KERN_ERR "Could not allocate memory during boot, "
"S3 disabled\n");
return -ENOMEM;
}
memcpy((void *)acpi_realmode, &wakeup_code_start, WAKEUP_SIZE);
acpi_realmode = TRAMPOLINE_SYM(acpi_wakeup_code);
header = (struct wakeup_header *)(acpi_realmode + HEADER_OFFSET);
if (header->signature != 0x51ee1111) {
header = (struct wakeup_header *)(acpi_realmode + WAKEUP_HEADER_OFFSET);
if (header->signature != WAKEUP_HEADER_SIGNATURE) {
printk(KERN_ERR "wakeup header does not match\n");
return -EINVAL;
}
......@@ -68,9 +59,7 @@ int acpi_save_state_mem(void)
/* GDT[0]: GDT self-pointer */
header->wakeup_gdt[0] =
(u64)(sizeof(header->wakeup_gdt) - 1) +
((u64)(acpi_wakeup_address +
((char *)&header->wakeup_gdt - (char *)acpi_realmode))
<< 16);
((u64)__pa(&header->wakeup_gdt) << 16);
/* GDT[1]: big real mode-like code segment */
header->wakeup_gdt[1] =
GDT_ENTRY(0x809b, acpi_wakeup_address, 0xfffff);
......@@ -96,7 +85,7 @@ int acpi_save_state_mem(void)
header->pmode_cr3 = (u32)__pa(&initial_page_table);
saved_magic = 0x12345678;
#else /* CONFIG_64BIT */
header->trampoline_segment = setup_trampoline() >> 4;
header->trampoline_segment = trampoline_address() >> 4;
#ifdef CONFIG_SMP
stack_start = (unsigned long)temp_stack + sizeof(temp_stack);
early_gdt_descr.address =
......@@ -117,46 +106,6 @@ void acpi_restore_state_mem(void)
{
}
/**
* acpi_reserve_wakeup_memory - do _very_ early ACPI initialisation
*
* We allocate a page from the first 1MB of memory for the wakeup
* routine for when we come back from a sleep state. The
* runtime allocator allows specification of <16MB pages, but not
* <1MB pages.
*/
void __init acpi_reserve_wakeup_memory(void)
{
phys_addr_t mem;
if ((&wakeup_code_end - &wakeup_code_start) > WAKEUP_SIZE) {
printk(KERN_ERR
"ACPI: Wakeup code way too big, S3 disabled.\n");
return;
}
mem = memblock_find_in_range(0, 1<<20, WAKEUP_SIZE, PAGE_SIZE);
if (mem == MEMBLOCK_ERROR) {
printk(KERN_ERR "ACPI: Cannot allocate lowmem, S3 disabled.\n");
return;
}
acpi_realmode = (unsigned long) phys_to_virt(mem);
acpi_wakeup_address = mem;
memblock_x86_reserve_range(mem, mem + WAKEUP_SIZE, "ACPI WAKEUP");
}
int __init acpi_configure_wakeup_memory(void)
{
if (acpi_realmode)
set_memory_x(acpi_realmode, WAKEUP_SIZE >> PAGE_SHIFT);
return 0;
}
arch_initcall(acpi_configure_wakeup_memory);
static int __init acpi_sleep_setup(char *str)
{
while ((str != NULL) && (*str != '\0')) {
......
......@@ -4,13 +4,10 @@
#include <asm/trampoline.h>
extern char wakeup_code_start, wakeup_code_end;
extern unsigned long saved_video_mode;
extern long saved_magic;
extern int wakeup_pmode_return;
extern char swsusp_pg_dir[PAGE_SIZE];
extern unsigned long acpi_copy_wakeup_routine(unsigned long);
extern void wakeup_long64(void);
......@@ -2,9 +2,11 @@
* Wrapper script for the realmode binary as a transport object
* before copying to low memory.
*/
.section ".rodata","a"
.globl wakeup_code_start, wakeup_code_end
wakeup_code_start:
#include <asm/page_types.h>
.section ".x86_trampoline","a"
.balign PAGE_SIZE
.globl acpi_wakeup_code
acpi_wakeup_code:
.incbin "arch/x86/kernel/acpi/realmode/wakeup.bin"
wakeup_code_end:
.size wakeup_code_start, .-wakeup_code_start
......@@ -937,13 +937,6 @@ void __init setup_arch(char **cmdline_p)
setup_trampolines();
#ifdef CONFIG_ACPI_SLEEP
/*
* Reserve low memory region for sleep support.
* even before init_memory_mapping
*/
acpi_reserve_wakeup_memory();
#endif
init_gbpages();
/* max_pfn_mapped is updated here */
......
......@@ -16,6 +16,7 @@
#include <linux/device.h>
#include <linux/suspend.h>
#include <linux/reboot.h>
#include <linux/acpi.h>
#include <asm/io.h>
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册