bnx2: Refine coalescing parameters.

- Set the USE_INT_PARAM bit so the rx-frames-irq and tx-frames-irq will take
  effect on 5709.
- Increase the default rx-frames to reduce interrupt count.
- Decrease the default rx-frames-irq and tx-frames-irq to catch more events
  during NAPI poll.

All these will reduce interrupts without affecting latency.
Signed-off-by: NMichael Chan <mchan@broadcom.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/bnx2.c

@@ -4921,7 +4921,7 @@ bnx2_init_chip(struct bnx2 *bp)
 	}
 
 	if (bp->flags & BNX2_FLAG_ONE_SHOT_MSI)
-		val |= BNX2_HC_CONFIG_ONE_SHOT;
+		val |= BNX2_HC_CONFIG_ONE_SHOT | BNX2_HC_CONFIG_USE_INT_PARAM;
 
 	REG_WR(bp, BNX2_HC_CONFIG, val);
 
@@ -7858,13 +7858,13 @@ bnx2_init_board(struct pci_dev *pdev, struct net_device *dev)
 
 	bp->rx_csum = 1;
 
-	bp->tx_quick_cons_trip_int = 20;
+	bp->tx_quick_cons_trip_int = 2;
 	bp->tx_quick_cons_trip = 20;
-	bp->tx_ticks_int = 80;
+	bp->tx_ticks_int = 18;
 	bp->tx_ticks = 80;
 
-	bp->rx_quick_cons_trip_int = 6;
-	bp->rx_quick_cons_trip = 6;
+	bp->rx_quick_cons_trip_int = 2;
+	bp->rx_quick_cons_trip = 12;
 	bp->rx_ticks_int = 18;
 	bp->rx_ticks = 18;