提交 cdf7bfa8 编写于 作者: D Devin Heitmueller 提交者: Mauro Carvalho Chehab

V4L/DVB (12100): em28xx: make sure the analog GPIOs are set if we used a card hint

In cases where the board had a default USB ID, we would not indentify the
board until after the call to em28xx_set_mode().  As a result, for those
boards the analog GPIOs were not being set before probing the i2c bus for
devices (the probe would occur with the GPIOs being all high).

Make a call to em28xx_set_mode() so that the GPIOs are set properly before
probing the i2c bus for devices.

This problem was detected with the EVGA inDtube, where the tvp5150 is not
powered on unless GPIO1 is pulled low.
Signed-off-by: NDevin Heitmueller <dheitmueller@kernellabs.com>
Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
上级 f867c3f4
......@@ -2101,6 +2101,12 @@ void em28xx_card_setup(struct em28xx *dev)
case EM2880_BOARD_MSI_DIGIVOX_AD:
if (!em28xx_hint_board(dev))
em28xx_set_model(dev);
/* In cases where we had to use a board hint, the call to
em28xx_set_mode() in em28xx_pre_card_setup() was a no-op,
so make the call now so the analog GPIOs are set properly
before probing the i2c bus. */
em28xx_set_mode(dev, EM28XX_ANALOG_MODE);
break;
}
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册