usb: chipidea: put hw_phymode_configure before ci_usb_phy_init

hw_phymode_configure configures the PORTSC registers and allow the
following phy_inits to operate on the right parameters. This fix a problem
where the UPLI (ISP1504) could not be detected, because the Viewport was not
available and read the viewport return 0's only.
Signed-off-by: NChris Ruehl <chris.ruehl@gtsys.com.hk>
Signed-off-by: NPeter Chen <peter.chen@freescale.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/chipidea/core.c

@@ -559,6 +559,8 @@ static int ci_hdrc_probe(struct platform_device *pdev)
 		return -ENODEV;
 	}
 
+	hw_phymode_configure(ci);
+
 	ret = ci_usb_phy_init(ci);
 	if (ret) {
 		dev_err(dev, "unable to init phy: %d\n", ret);
@@ -576,8 +578,6 @@ static int ci_hdrc_probe(struct platform_device *pdev)
 
 	ci_get_otg_capable(ci);
 
-	hw_phymode_configure(ci);
-
 	dr_mode = ci->platdata->dr_mode;
 	/* initialize role(s) before the interrupt is requested */
 	if (dr_mode == USB_DR_MODE_OTG || dr_mode == USB_DR_MODE_HOST) {