提交 ccad7b44 编写于 作者: K Kuninori Morimoto 提交者: Mark Brown

ASoC: fsi: Fixup for master mode

This patch add hw_params to snd_soc_dai_ops,
because board specific set_rate is needed
when FSI was used as master mode.

This patch remove fsi_clk_ctrl from fsi_dai_startup,
because clock should be disabled before set_rate.
Signed-off-by: NKuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Acked-by: NLiam Girdwood <lrg@slimlogic.co.uk>
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
上级 d7854147
......@@ -72,9 +72,41 @@
#define SH_FSI_OFMT_TDM_DELAY_CH(x) \
(SH_FSI_OFMT(TDM_DELAY) | SH_FSI_SET_CH_O(x))
/*
* set_rate return value
*
* see ACKMD/BPFMD on
* ACK_MD (FSI2)
* CKG1 (FSI)
*
* err: return value < 0
*
* 0x-00000AB
*
* A: ACKMD value
* B: BPFMD value
*/
#define SH_FSI_ACKMD_MASK (0xF << 0)
#define SH_FSI_ACKMD_512 (1 << 0)
#define SH_FSI_ACKMD_256 (2 << 0)
#define SH_FSI_ACKMD_128 (3 << 0)
#define SH_FSI_ACKMD_64 (4 << 0)
#define SH_FSI_ACKMD_32 (5 << 0)
#define SH_FSI_BPFMD_MASK (0xF << 4)
#define SH_FSI_BPFMD_512 (1 << 4)
#define SH_FSI_BPFMD_256 (2 << 4)
#define SH_FSI_BPFMD_128 (3 << 4)
#define SH_FSI_BPFMD_64 (4 << 4)
#define SH_FSI_BPFMD_32 (5 << 4)
#define SH_FSI_BPFMD_16 (6 << 4)
struct sh_fsi_platform_info {
unsigned long porta_flags;
unsigned long portb_flags;
int (*set_rate)(int is_porta, int rate); /* for master mode */
};
extern struct snd_soc_dai fsi_soc_dai[2];
......
......@@ -65,6 +65,10 @@
#define ERR_UNDER 0x00000001
#define ST_ERR (ERR_OVER | ERR_UNDER)
/* CKG1 */
#define ACKMD_MASK 0x00007000
#define BPFMD_MASK 0x00000700
/* CLK_RST */
#define B_CLK 0x00000010
#define A_CLK 0x00000001
......@@ -734,12 +738,6 @@ static int fsi_dai_startup(struct snd_pcm_substream *substream,
}
fsi_reg_write(fsi, reg, data);
/*
* clear clk reset if master mode
*/
if (is_master)
fsi_clk_ctrl(fsi, 1);
/* irq clear */
fsi_irq_disable(fsi, is_play);
fsi_irq_clear_status(fsi);
......@@ -786,10 +784,98 @@ static int fsi_dai_trigger(struct snd_pcm_substream *substream, int cmd,
return ret;
}
static int fsi_dai_hw_params(struct snd_pcm_substream *substream,
struct snd_pcm_hw_params *params,
struct snd_soc_dai *dai)
{
struct fsi_priv *fsi = fsi_get_priv(substream);
struct fsi_master *master = fsi_get_master(fsi);
int (*set_rate)(int is_porta, int rate) = master->info->set_rate;
int fsi_ver = master->core->ver;
int is_play = (substream->stream == SNDRV_PCM_STREAM_PLAYBACK);
int ret;
/* if slave mode, set_rate is not needed */
if (!fsi_is_master_mode(fsi, is_play))
return 0;
/* it is error if no set_rate */
if (!set_rate)
return -EIO;
/* clock stop */
pm_runtime_put_sync(dai->dev);
fsi_clk_ctrl(fsi, 0);
ret = set_rate(fsi_is_port_a(fsi), params_rate(params));
if (ret > 0) {
u32 data = 0;
switch (ret & SH_FSI_ACKMD_MASK) {
default:
/* FALL THROUGH */
case SH_FSI_ACKMD_512:
data |= (0x0 << 12);
break;
case SH_FSI_ACKMD_256:
data |= (0x1 << 12);
break;
case SH_FSI_ACKMD_128:
data |= (0x2 << 12);
break;
case SH_FSI_ACKMD_64:
data |= (0x3 << 12);
break;
case SH_FSI_ACKMD_32:
if (fsi_ver < 2)
dev_err(dai->dev, "unsupported ACKMD\n");
else
data |= (0x4 << 12);
break;
}
switch (ret & SH_FSI_BPFMD_MASK) {
default:
/* FALL THROUGH */
case SH_FSI_BPFMD_32:
data |= (0x0 << 8);
break;
case SH_FSI_BPFMD_64:
data |= (0x1 << 8);
break;
case SH_FSI_BPFMD_128:
data |= (0x2 << 8);
break;
case SH_FSI_BPFMD_256:
data |= (0x3 << 8);
break;
case SH_FSI_BPFMD_512:
data |= (0x4 << 8);
break;
case SH_FSI_BPFMD_16:
if (fsi_ver < 2)
dev_err(dai->dev, "unsupported ACKMD\n");
else
data |= (0x7 << 8);
break;
}
fsi_reg_mask_set(fsi, CKG1, (ACKMD_MASK | BPFMD_MASK) , data);
udelay(10);
fsi_clk_ctrl(fsi, 1);
ret = 0;
}
pm_runtime_get_sync(dai->dev);
return ret;
}
static struct snd_soc_dai_ops fsi_dai_ops = {
.startup = fsi_dai_startup,
.shutdown = fsi_dai_shutdown,
.trigger = fsi_dai_trigger,
.hw_params = fsi_dai_hw_params,
};
/************************************************************************
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册