提交 cbd18f8e 编写于 作者: E Eric Miao 提交者: Russell King

[ARM] pxa: make additional DCSR bits valid for PXA3xx

Signed-off-by: NEric Miao <eric.miao@marvell.com>
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
上级 283afa06
......@@ -92,7 +92,13 @@
#define DCSR_RUN (1 << 31) /* Run Bit (read / write) */
#define DCSR_NODESC (1 << 30) /* No-Descriptor Fetch (read / write) */
#define DCSR_STOPIRQEN (1 << 29) /* Stop Interrupt Enable (read / write) */
#ifdef CONFIG_PXA27x
#define DCSR_REQPEND (1 << 8) /* Request Pending (read-only) */
#define DCSR_STOPSTATE (1 << 3) /* Stop State (read-only) */
#define DCSR_ENDINTR (1 << 2) /* End Interrupt (read / write) */
#define DCSR_STARTINTR (1 << 1) /* Start Interrupt (read / write) */
#define DCSR_BUSERR (1 << 0) /* Bus Error Interrupt (read / write) */
#if defined(CONFIG_PXA27x) || defined(CONFIG_PXA3xx)
#define DCSR_EORIRQEN (1 << 28) /* End of Receive Interrupt Enable (R/W) */
#define DCSR_EORJMPEN (1 << 27) /* Jump to next descriptor on EOR */
#define DCSR_EORSTOPEN (1 << 26) /* STOP on an EOR */
......@@ -101,11 +107,6 @@
#define DCSR_CMPST (1 << 10) /* The Descriptor Compare Status */
#define DCSR_EORINTR (1 << 9) /* The end of Receive */
#endif
#define DCSR_REQPEND (1 << 8) /* Request Pending (read-only) */
#define DCSR_STOPSTATE (1 << 3) /* Stop State (read-only) */
#define DCSR_ENDINTR (1 << 2) /* End Interrupt (read / write) */
#define DCSR_STARTINTR (1 << 1) /* Start Interrupt (read / write) */
#define DCSR_BUSERR (1 << 0) /* Bus Error Interrupt (read / write) */
#define DALGN __REG(0x400000a0) /* DMA Alignment Register */
#define DINT __REG(0x400000f0) /* DMA Interrupt Register */
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册