bnx2x: Limit 1G link enforcement

Change 1G-SFP module detection by verifying not only that it's not
compliant with 10G-Ethernet, but also that it's 1G-ethernet compliant.
Signed-off-by: NYaniv Rosner <Yaniv.Rosner@qlogic.com>
Signed-off-by: NYuval Mintz <Yuval.Mintz@qlogic.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c

@@ -8119,10 +8119,11 @@ static int bnx2x_get_edc_mode(struct bnx2x_phy *phy,
 	case SFP_EEPROM_CON_TYPE_VAL_LC:
 	case SFP_EEPROM_CON_TYPE_VAL_RJ45:
 		check_limiting_mode = 1;
-		if ((val[SFP_EEPROM_10G_COMP_CODE_ADDR] &
+		if (((val[SFP_EEPROM_10G_COMP_CODE_ADDR] &
 		     (SFP_EEPROM_10G_COMP_CODE_SR_MASK |
 		      SFP_EEPROM_10G_COMP_CODE_LR_MASK |
-		      SFP_EEPROM_10G_COMP_CODE_LRM_MASK)) == 0) {
+		       SFP_EEPROM_10G_COMP_CODE_LRM_MASK)) == 0) &&
+		    (val[SFP_EEPROM_1G_COMP_CODE_ADDR] != 0)) {
 			DP(NETIF_MSG_LINK, "1G SFP module detected\n");
 			phy->media_type = ETH_PHY_SFP_1G_FIBER;
 			if (phy->req_line_speed != SPEED_1000) {