提交 c4e67bbc 编写于 作者: L Lee Jones 提交者: Mark Brown

ARM: ux500: Pass regulator platform data using the new format

Regulator platform data is now passed though a single structure
as opposed to the old way where four separate struct elements
were required. This patch makes use of the new format.
Signed-off-by: NLee Jones <lee.jones@linaro.org>
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
上级 d3193103
......@@ -198,10 +198,7 @@ static struct platform_device snowball_sbnet_dev = {
struct ab8500_platform_data ab8500_platdata = {
.irq_base = MOP500_AB8500_IRQ_BASE,
.regulator_reg_init = ab8500_regulator_reg_init,
.num_regulator_reg_init = ARRAY_SIZE(ab8500_regulator_reg_init),
.regulator = ab8500_regulators,
.num_regulator = ARRAY_SIZE(ab8500_regulators),
.regulator = &ab8500_regulator_plat_data,
.gpio = &ab8500_gpio_pdata,
.codec = &ab8500_codec_pdata,
};
......
......@@ -364,8 +364,7 @@ struct ab8500 {
const int *irq_reg_offset;
};
struct regulator_reg_init;
struct regulator_init_data;
struct ab8500_regulator_platform_data;
struct ab8500_gpio_platform_data;
struct ab8500_codec_platform_data;
struct ab8500_sysctrl_platform_data;
......@@ -375,19 +374,13 @@ struct ab8500_sysctrl_platform_data;
* @irq_base: start of AB8500 IRQs, AB8500_NR_IRQS will be used
* @pm_power_off: Should machine pm power off hook be registered or not
* @init: board-specific initialization after detection of ab8500
* @num_regulator_reg_init: number of regulator init registers
* @regulator_reg_init: regulator init registers
* @num_regulator: number of regulators
* @regulator: machine-specific constraints for regulators
*/
struct ab8500_platform_data {
int irq_base;
bool pm_power_off;
void (*init) (struct ab8500 *);
int num_regulator_reg_init;
struct ab8500_regulator_reg_init *regulator_reg_init;
int num_regulator;
struct regulator_init_data *regulator;
struct ab8500_regulator_platform_data *regulator;
struct abx500_gpio_platform_data *gpio;
struct ab8500_codec_platform_data *codec;
struct ab8500_sysctrl_platform_data *sysctrl;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册