rcu: demote SRCU_SYNCHRONIZE_DELAY from kernel-parameter status

Because the adaptive synchronize_srcu_expedited() approach has
worked very well in testing, remove the kernel parameter and
replace it by a C-preprocessor macro.  If someone finds problems
with this approach, a more complex and aggressively adaptive
approach might be required.

Longer term, SRCU will be merged with the other RCU implementations,
at which point synchronize_srcu_expedited() will be event driven,
just as synchronize_sched_expedited() currently is.  At that point,
there will be no need for this adaptive approach.
Reported-by: NLinus Torvalds <torvalds@linux-foundation.org>
Signed-off-by: NPaul E. McKenney <paulmck@linux.vnet.ibm.com>

init/Kconfig

@@ -497,21 +497,6 @@ config RCU_BOOST_DELAY
 
 	  Accept the default if unsure.
 
-config SRCU_SYNCHRONIZE_DELAY
-	int "Microseconds to delay before waiting for readers"
-	range 0 20
-	default 10
-	help
-	  This option controls how long SRCU delays before entering its
-	  loop waiting on SRCU readers.  The purpose of this loop is
-	  to avoid the unconditional context-switch penalty that would
-	  otherwise be incurred if there was an active SRCU reader,
-	  in a manner similar to adaptive locking schemes.  This should
-	  be set to be a bit longer than the common-case SRCU read-side
-	  critical-section overhead.
-
-	  Accept the default if unsure.
-
 endmenu # "RCU Subsystem"
 
 config IKCONFIG

kernel/srcu.c

@@ -155,6 +155,16 @@ void __srcu_read_unlock(struct srcu_struct *sp, int idx)
 }
 EXPORT_SYMBOL_GPL(__srcu_read_unlock);
 
+/*
+ * We use an adaptive strategy for synchronize_srcu() and especially for
+ * synchronize_srcu_expedited().  We spin for a fixed time period
+ * (defined below) to allow SRCU readers to exit their read-side critical
+ * sections.  If there are still some readers after 10 microseconds,
+ * we repeatedly block for 1-millisecond time periods.  This approach
+ * has done well in testing, so there is no need for a config parameter.
+ */
+#define SYNCHRONIZE_SRCU_READER_DELAY 10
+
 /*
  * Helper function for synchronize_srcu() and synchronize_srcu_expedited().
  */
@@ -207,11 +217,12 @@ static void __synchronize_srcu(struct srcu_struct *sp, void (*sync_func)(void))
 	 * will have finished executing.  We initially give readers
 	 * an arbitrarily chosen 10 microseconds to get out of their
 	 * SRCU read-side critical sections, then loop waiting 1/HZ
-	 * seconds per iteration.
+	 * seconds per iteration.  The 10-microsecond value has done
+	 * very well in testing.
 	 */
 
 	if (srcu_readers_active_idx(sp, idx))
-		udelay(CONFIG_SRCU_SYNCHRONIZE_DELAY);
+		udelay(SYNCHRONIZE_SRCU_READER_DELAY);
 	while (srcu_readers_active_idx(sp, idx))
 		schedule_timeout_interruptible(1);