提交 bc27ede3 编写于 作者: J Jamie Iles 提交者: Artem Bityutskiy

mtd: denali: detect the number of banks before resetting NAND

Commit c89eeda8 (mtd: denali: detect the
number of banks) introduced runtime detection of the number of banks.

However, denali_nand_reset() uses uses denanli_nand_info::max_banks so
we need to detect the maximum number of banks before doing the reset.
Signed-off-by: NJamie Iles <jamie@jamieiles.com>
Signed-off-by: NArtem Bityutskiy <Artem.Bityutskiy@nokia.com>
上级 0dc8626a
......@@ -1346,6 +1346,7 @@ static void denali_hw_init(struct denali_nand_info *denali)
* */
denali->bbtskipbytes = ioread32(denali->flash_reg +
SPARE_AREA_SKIP_BYTES);
detect_max_banks(denali);
denali_nand_reset(denali);
iowrite32(0x0F, denali->flash_reg + RB_PIN_ENABLED);
iowrite32(CHIP_EN_DONT_CARE__FLAG,
......@@ -1356,7 +1357,6 @@ static void denali_hw_init(struct denali_nand_info *denali)
/* Should set value for these registers when init */
iowrite32(0, denali->flash_reg + TWO_ROW_ADDR_CYCLES);
iowrite32(1, denali->flash_reg + ECC_ENABLE);
detect_max_banks(denali);
denali_nand_timing_set(denali);
denali_irq_init(denali);
}
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册