drivers/video/udlfb match class, subclass, and protocol

Match udlfb only against vendor-specific class (e.g. only DisplayLink
graphics, not composite standard audio class interfaces). This enables
compatibility with composite graphics+audio devices (e.g. HDMI).

Match udlfb only against compatible subclass 0 and protocol 0 chips.
DisplayLink's USB 3.0 generation chips increment these values
to signal that they have a incompatible protocol, preventing udlfb
from erroneously matching to hardware it does not support.

Tested to confirm proper behavior on both USB 2.0 and USB 3.0
generation devices.
Reported-by: NAndrew Kephart <akephart@akephart.org>
Signed-off-by: NBernie Thompson <bernie@plugable.com>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

drivers/video/udlfb.c

@@ -49,13 +49,22 @@ static const u32 udlfb_info_flags = FBINFO_DEFAULT | FBINFO_READS_FAST |
 		FBINFO_HWACCEL_COPYAREA | FBINFO_MISC_ALWAYS_SETPAR;
 
 /*
- * There are many DisplayLink-based products, all with unique PIDs. We are able
- * to support all volume ones (circa 2009) with a single driver, so we match
- * globally on VID. TODO: Probe() needs to detect when we might be running
- * "future" chips, and bail on those, so a compatible driver can match.
+ * There are many DisplayLink-based graphics products, all with unique PIDs.
+ * So we match on DisplayLink's VID + Vendor-Defined Interface Class (0xff)
+ * We also require a match on SubClass (0x00) and Protocol (0x00),
+ * which is compatible with all known USB 2.0 era graphics chips and firmware,
+ * but allows DisplayLink to increment those for any future incompatible chips
  */
 static struct usb_device_id id_table[] = {
-	{.idVendor = 0x17e9, .match_flags = USB_DEVICE_ID_MATCH_VENDOR,},
+	{.idVendor = 0x17e9,
+	 .bInterfaceClass = 0xff,
+	 .bInterfaceSubClass = 0x00,
+	 .bInterfaceProtocol = 0x00,
+	 .match_flags = USB_DEVICE_ID_MATCH_VENDOR |
+		USB_DEVICE_ID_MATCH_INT_CLASS |
+		USB_DEVICE_ID_MATCH_INT_SUBCLASS |
+		USB_DEVICE_ID_MATCH_INT_PROTOCOL,
+	},
 	{},
 };
 MODULE_DEVICE_TABLE(usb, id_table);