提交 a8884e34 编写于 作者: M Michael Trimarchi 提交者: Paul Mundt

sh: Fix up the shared IRQ demuxer's control bit testing logic.

Correct the interrupt handler in sh4 serial device, return the correct
value and check for what is anabled in the SCSCR register. The sh7722 is
broken just sending a break using minicom.
Signed-off-by: NMichael Trimarchi <trimarchimichael@yahoo.it>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>
上级 7abc404a
......@@ -797,26 +797,27 @@ static irqreturn_t sci_br_interrupt(int irq, void *ptr)
static irqreturn_t sci_mpxed_interrupt(int irq, void *ptr)
{
unsigned short ssr_status, scr_status;
struct uart_port *port = ptr;
unsigned short ssr_status, scr_status;
struct uart_port *port = ptr;
irqreturn_t ret = IRQ_NONE;
ssr_status = sci_in(port,SCxSR);
scr_status = sci_in(port,SCSCR);
/* Tx Interrupt */
if ((ssr_status & 0x0020) && (scr_status & 0x0080))
sci_tx_interrupt(irq, ptr);
if ((ssr_status & 0x0020) && (scr_status & SCI_CTRL_FLAGS_TIE))
ret = sci_tx_interrupt(irq, ptr);
/* Rx Interrupt */
if ((ssr_status & 0x0002) && (scr_status & 0x0040))
sci_rx_interrupt(irq, ptr);
if ((ssr_status & 0x0002) && (scr_status & SCI_CTRL_FLAGS_RIE))
ret = sci_rx_interrupt(irq, ptr);
/* Error Interrupt */
if ((ssr_status & 0x0080) && (scr_status & 0x0400))
sci_er_interrupt(irq, ptr);
if ((ssr_status & 0x0080) && (scr_status & SCI_CTRL_FLAGS_REIE))
ret = sci_er_interrupt(irq, ptr);
/* Break Interrupt */
if ((ssr_status & 0x0010) && (scr_status & 0x0200))
sci_br_interrupt(irq, ptr);
if ((ssr_status & 0x0010) && (scr_status & SCI_CTRL_FLAGS_REIE))
ret = sci_br_interrupt(irq, ptr);
return IRQ_HANDLED;
return ret;
}
#if defined(CONFIG_CPU_FREQ) && defined(CONFIG_HAVE_CLK)
......
......@@ -166,6 +166,7 @@
#if defined(CONFIG_CPU_SUBTYPE_SH7750) || \
defined(CONFIG_CPU_SUBTYPE_SH7091) || \
defined(CONFIG_CPU_SUBTYPE_SH7750R) || \
defined(CONFIG_CPU_SUBTYPE_SH7722) || \
defined(CONFIG_CPU_SUBTYPE_SH7750S) || \
defined(CONFIG_CPU_SUBTYPE_SH7751) || \
defined(CONFIG_CPU_SUBTYPE_SH7751R) || \
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册