提交 a47aaa69 编写于 作者: R Raja Mani 提交者: Kalle Valo

dt: bindings: add new dt entry for pre calibration in qcom, ath10k.txt

There two things done in this patch,

1) Existing device tree entry 'qcom,ath10k-calibration-data' carries
   not only calibration data, it carries board specific data too.
   So, make appropriate update in doc.

2) ipq4019 wifi needs new devie tree entry to carry calibration
   data alone (called pre cal data, it doesn't include any other info).
   Using 'qcom,ath10k-calibration-data' for ipq4019 would alter
   the purpose of it. Hence, add new device tree entry called
   'qcom,ath10k-pre-calibration-data' to carry only pre calibration data.
Signed-off-by: NRaja Mani <rmani@qti.qualcomm.com>
Acked-by: NRob Herring <robh@kernel.org>
Signed-off-by: NKalle Valo <kvalo@qca.qualcomm.com>
上级 8866c727
......@@ -5,12 +5,18 @@ Required properties:
* "qcom,ath10k"
* "qcom,ipq4019-wifi"
PCI based devices uses compatible string "qcom,ath10k" and takes only
calibration data via "qcom,ath10k-calibration-data". Rest of the properties
are not applicable for PCI based devices.
PCI based devices uses compatible string "qcom,ath10k" and takes calibration
data along with board specific data via "qcom,ath10k-calibration-data".
Rest of the properties are not applicable for PCI based devices.
AHB based devices (i.e. ipq4019) uses compatible string "qcom,ipq4019-wifi"
and also uses most of the properties defined in this doc.
and also uses most of the properties defined in this doc (except
"qcom,ath10k-calibration-data"). It uses "qcom,ath10k-pre-calibration-data"
to carry pre calibration data.
In general, entry "qcom,ath10k-pre-calibration-data" and
"qcom,ath10k-calibration-data" conflict with each other and only one
can be provided per device.
Optional properties:
- reg: Address and length of the register set for the device.
......@@ -35,8 +41,11 @@ Optional properties:
- qcom,msi_addr: MSI interrupt address.
- qcom,msi_base: Base value to add before writing MSI data into
MSI address register.
- qcom,ath10k-calibration-data : calibration data as an array, the
length can vary between hw versions
- qcom,ath10k-calibration-data : calibration data + board specific data
as an array, the length can vary between
hw versions.
- qcom,ath10k-pre-calibration-data : pre calibration data as an array,
the length can vary between hw versions.
Example (to supply the calibration data alone):
......@@ -105,5 +114,5 @@ wifi0: wifi@a000000 {
"legacy";
qcom,msi_addr = <0x0b006040>;
qcom,msi_base = <0x40>;
qcom,ath10k-calibration-data = [ 01 02 03 ... ];
qcom,ath10k-pre-calibration-data = [ 01 02 03 ... ];
};
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册