drbd: always write bitmap on detach

If we detach due to local read-error (which sets a bit in the bitmap),
stay Primary, and then re-attach (which re-reads the bitmap from disk),
we potentially lost the "out-of-sync" (or, "bad block") information in
the bitmap.

Always (try to) write out the changed bitmap pages before going diskless.

That way, we don't lose the bit for the bad block,
the next resync will fetch it from the peer, and rewrite
it locally, which may result in block reallocation in some
lower layer (or the hardware), and thereby "heal" the bad blocks.

If the bitmap writeout errors out as well, we will (again: try to)
mark the "we need a full sync" bit in our super block,
if it was a READ error; writes are covered by the activity log already.

If that superblock does not make it to disk either, we are sorry.

Maybe we just lost an entire disk or controller (or iSCSI connection),
and there actually are no bad blocks at all, so we don't need to
re-fetch from the peer, there is no "auto-healing" necessary.
Signed-off-by: NPhilipp Reisner <philipp.reisner@linbit.com>
Signed-off-by: NLars Ellenberg <lars.ellenberg@linbit.com>
Signed-off-by: NJens Axboe <axboe@kernel.dk>

drivers/block/drbd/drbd_int.h

@@ -831,7 +831,8 @@ enum drbd_flag {
 				   once no more io in flight, start bitmap io */
 	BITMAP_IO_QUEUED,       /* Started bitmap IO */
 	GO_DISKLESS,		/* Disk is being detached, on io-error or admin request. */
-	WAS_IO_ERROR,		/* Local disk failed returned IO error */
+	WAS_IO_ERROR,		/* Local disk failed, returned IO error */
+	WAS_READ_ERROR,		/* Local disk READ failed (set additionally to the above) */
 	FORCE_DETACH,		/* Force-detach from local disk, aborting any pending local IO */
 	RESYNC_AFTER_NEG,       /* Resync after online grow after the attach&negotiate finished. */
 	NET_CONGESTED,		/* The data socket is congested */
@@ -1879,30 +1880,53 @@ static inline int drbd_request_state(struct drbd_conf *mdev,
 }
 
 enum drbd_force_detach_flags {
-	DRBD_IO_ERROR,
+	DRBD_READ_ERROR,
+	DRBD_WRITE_ERROR,
 	DRBD_META_IO_ERROR,
 	DRBD_FORCE_DETACH,
 };
 
 #define __drbd_chk_io_error(m,f) __drbd_chk_io_error_(m,f, __func__)
 static inline void __drbd_chk_io_error_(struct drbd_conf *mdev,
-		enum drbd_force_detach_flags forcedetach,
+		enum drbd_force_detach_flags df,
 		const char *where)
 {
 	switch (mdev->ldev->dc.on_io_error) {
 	case EP_PASS_ON:
-		if (forcedetach == DRBD_IO_ERROR) {
+		if (df == DRBD_READ_ERROR || df == DRBD_WRITE_ERROR) {
 			if (__ratelimit(&drbd_ratelimit_state))
 				dev_err(DEV, "Local IO failed in %s.\n", where);
 			if (mdev->state.disk > D_INCONSISTENT)
 				_drbd_set_state(_NS(mdev, disk, D_INCONSISTENT), CS_HARD, NULL);
 			break;
 		}
-		/* NOTE fall through to detach case if forcedetach set */
+		/* NOTE fall through for DRBD_META_IO_ERROR or DRBD_FORCE_DETACH */
 	case EP_DETACH:
 	case EP_CALL_HELPER:
+		/* Remember whether we saw a READ or WRITE error.
+		 *
+		 * Recovery of the affected area for WRITE failure is covered
+		 * by the activity log.
+		 * READ errors may fall outside that area though. Certain READ
+		 * errors can be "healed" by writing good data to the affected
+		 * blocks, which triggers block re-allocation in lower layers.
+		 *
+		 * If we can not write the bitmap after a READ error,
+		 * we may need to trigger a full sync (see w_go_diskless()).
+		 *
+		 * Force-detach is not really an IO error, but rather a
+		 * desperate measure to try to deal with a completely
+		 * unresponsive lower level IO stack.
+		 * Still it should be treated as a WRITE error.
+		 *
+		 * Meta IO error is always WRITE error:
+		 * we read meta data only once during attach,
+		 * which will fail in case of errors.
+		 */
 		drbd_set_flag(mdev, WAS_IO_ERROR);
-		if (forcedetach == DRBD_FORCE_DETACH)
+		if (df == DRBD_READ_ERROR)
+			drbd_set_flag(mdev, WAS_READ_ERROR);
+		if (df == DRBD_FORCE_DETACH)
 			drbd_set_flag(mdev, FORCE_DETACH);
 		if (mdev->state.disk > D_FAILED) {
 			_drbd_set_state(_NS(mdev, disk, D_FAILED), CS_HARD, NULL);

drivers/block/drbd/drbd_main.c

@@ -1617,17 +1617,20 @@ static void after_state_ch(struct drbd_conf *mdev, union drbd_state os,
 	/* first half of local IO error, failure to attach,
 	 * or administrative detach */
 	if (os.disk != D_FAILED && ns.disk == D_FAILED) {
-		enum drbd_io_error_p eh = EP_PASS_ON;
-		int was_io_error = 0;
 		/* corresponding get_ldev was in __drbd_set_state, to serialize
 		 * our cleanup here with the transition to D_DISKLESS.
-		 * But is is still not save to dreference ldev here, since
-		 * we might come from an failed Attach before ldev was set. */
+		 * But it is still not safe to dreference ldev here, we may end
+		 * up here from a failed attach, before ldev was even set.  */
 		if (mdev->ldev) {
-			eh = mdev->ldev->dc.on_io_error;
-			was_io_error = drbd_test_and_clear_flag(mdev, WAS_IO_ERROR);
-
-			if (was_io_error && eh == EP_CALL_HELPER)
+			enum drbd_io_error_p eh = mdev->ldev->dc.on_io_error;
+
+			/* In some setups, this handler triggers a suicide,
+			 * basically mapping IO error to node failure, to
+			 * reduce the number of different failure scenarios.
+			 *
+			 * This handler intentionally runs before we abort IO,
+			 * notify the peer, or try to update our meta data. */
+			if (eh == EP_CALL_HELPER && drbd_test_flag(mdev, WAS_IO_ERROR))
 				drbd_khelper(mdev, "local-io-error");
 
 			/* Immediately allow completion of all application IO,
@@ -1643,7 +1646,7 @@ static void after_state_ch(struct drbd_conf *mdev, union drbd_state os,
 			 * So aborting local requests may cause crashes,
 			 * or even worse, silent data corruption.
 			 */
-			if (drbd_test_and_clear_flag(mdev, FORCE_DETACH))
+			if (drbd_test_flag(mdev, FORCE_DETACH))
 				tl_abort_disk_io(mdev);
 
 			/* current state still has to be D_FAILED,
@@ -4220,6 +4223,26 @@ static int w_go_diskless(struct drbd_conf *mdev, struct drbd_work *w, int unused
 	 * inc/dec it frequently. Once we are D_DISKLESS, no one will touch
 	 * the protected members anymore, though, so once put_ldev reaches zero
 	 * again, it will be safe to free them. */
+
+	/* Try to write changed bitmap pages, read errors may have just
+	 * set some bits outside the area covered by the activity log.
+	 *
+	 * If we have an IO error during the bitmap writeout,
+	 * we will want a full sync next time, just in case.
+	 * (Do we want a specific meta data flag for this?)
+	 *
+	 * If that does not make it to stable storage either,
+	 * we cannot do anything about that anymore.  */
+	if (mdev->bitmap) {
+		if (drbd_bitmap_io_from_worker(mdev, drbd_bm_write,
+					"detach", BM_LOCKED_MASK)) {
+			if (drbd_test_flag(mdev, WAS_READ_ERROR)) {
+				drbd_md_set_flag(mdev, MDF_FULL_SYNC);
+				drbd_md_sync(mdev);
+			}
+		}
+	}
+
 	drbd_force_state(mdev, NS(disk, D_DISKLESS));
 	return 1;
 }

drivers/block/drbd/drbd_nl.c

@@ -959,6 +959,8 @@ static int drbd_nl_disk_conf(struct drbd_conf *mdev, struct drbd_nl_cfg_req *nlp
 
 	/* make sure there is no leftover from previous force-detach attempts */
 	drbd_clear_flag(mdev, FORCE_DETACH);
+	drbd_clear_flag(mdev, WAS_IO_ERROR);
+	drbd_clear_flag(mdev, WAS_READ_ERROR);
 
 	/* and no leftover from previously aborted resync or verify, either */
 	mdev->rs_total = 0;

drivers/block/drbd/drbd_req.c

@@ -455,7 +455,7 @@ int __req_mod(struct drbd_request *req, enum drbd_req_event what,
 		req->rq_state |= RQ_LOCAL_COMPLETED;
 		req->rq_state &= ~RQ_LOCAL_PENDING;
 
-		__drbd_chk_io_error(mdev, DRBD_IO_ERROR);
+		__drbd_chk_io_error(mdev, DRBD_WRITE_ERROR);
 		_req_may_be_done_not_susp(req, m);
 		break;
 
@@ -477,7 +477,7 @@ int __req_mod(struct drbd_request *req, enum drbd_req_event what,
 			break;
 		}
 
-		__drbd_chk_io_error(mdev, DRBD_IO_ERROR);
+		__drbd_chk_io_error(mdev, DRBD_READ_ERROR);
 
 	goto_queue_for_net_read:
 

drivers/block/drbd/drbd_worker.c

@@ -111,7 +111,7 @@ void drbd_endio_read_sec_final(struct drbd_epoch_entry *e) __releases(local)
 	if (list_empty(&mdev->read_ee))
 		wake_up(&mdev->ee_wait);
 	if (test_bit(__EE_WAS_ERROR, &e->flags))
-		__drbd_chk_io_error(mdev, DRBD_IO_ERROR);
+		__drbd_chk_io_error(mdev, DRBD_READ_ERROR);
 	spin_unlock_irqrestore(&mdev->req_lock, flags);
 
 	drbd_queue_work(&mdev->data.work, &e->w);
@@ -154,7 +154,7 @@ static void drbd_endio_write_sec_final(struct drbd_epoch_entry *e) __releases(lo
 		: list_empty(&mdev->active_ee);
 
 	if (test_bit(__EE_WAS_ERROR, &e->flags))
-		__drbd_chk_io_error(mdev, DRBD_IO_ERROR);
+		__drbd_chk_io_error(mdev, DRBD_WRITE_ERROR);
 	spin_unlock_irqrestore(&mdev->req_lock, flags);
 
 	if (is_syncer_req)