提交 a24b88b5 编写于 作者: S Sujith Manoharan 提交者: Kalle Valo

ath10k: Fix bug in max. VHT A-MPDU size

For VHT peers, the maximum A-MPDU size has to be calculated
from the VHT capabilities element and not the HT-cap. The formula
is the same, but a higher value is used in VHT, allowing larger
aggregates to be transmitted.

The patch contains a workaround for some Netgear/Linksys APs that
report Rx A-MPDU factor incorrectly.
Tested-by: NKalle Valo <kvalo@qca.qualcomm.com>
Signed-off-by: NSujith Manoharan <c_manoha@qca.qualcomm.com>
Signed-off-by: NMichal Kazior <michal.kazior@tieto.com>
Signed-off-by: NKalle Valo <kvalo@qca.qualcomm.com>
上级 0d1a28f2
......@@ -1033,14 +1033,27 @@ static void ath10k_peer_assoc_h_vht(struct ath10k *ar,
struct wmi_peer_assoc_complete_arg *arg)
{
const struct ieee80211_sta_vht_cap *vht_cap = &sta->vht_cap;
u8 ampdu_factor;
if (!vht_cap->vht_supported)
return;
arg->peer_flags |= WMI_PEER_VHT;
arg->peer_vht_caps = vht_cap->cap;
ampdu_factor = (vht_cap->cap &
IEEE80211_VHT_CAP_MAX_A_MPDU_LENGTH_EXPONENT_MASK) >>
IEEE80211_VHT_CAP_MAX_A_MPDU_LENGTH_EXPONENT_SHIFT;
/* Workaround: Some Netgear/Linksys 11ac APs set Rx A-MPDU factor to
* zero in VHT IE. Using it would result in degraded throughput.
* arg->peer_max_mpdu at this point contains HT max_mpdu so keep
* it if VHT max_mpdu is smaller. */
arg->peer_max_mpdu = max(arg->peer_max_mpdu,
(1U << (IEEE80211_HT_MAX_AMPDU_FACTOR +
ampdu_factor)) - 1);
if (sta->bandwidth == IEEE80211_STA_RX_BW_80)
arg->peer_flags |= WMI_PEER_80MHZ;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册