drm/i915/irq: move hotplug even debug print to second connector loop

The hotplug work function has two loops iterating over connectors, the
first for handling hotplug disabling due to irq storms and the second
for actually handling the hotplug events. Move the debug printing into
the second one, so we can abstract the storm handling better. This may
change the output ordering slightly when there are multiple simultaneous
hotplug events.
Signed-off-by: NJani Nikula <jani.nikula@intel.com>
Signed-off-by: NDaniel Vetter <daniel.vetter@ffwll.ch>

drivers/gpu/drm/i915/i915_irq.c

@@ -917,10 +917,6 @@ static void i915_hotplug_work_func(struct work_struct *work)
 				| DRM_CONNECTOR_POLL_DISCONNECT;
 			hpd_disabled = true;
 		}
-		if (hpd_event_bits & (1 << intel_encoder->hpd_pin)) {
-			DRM_DEBUG_KMS("Connector %s (pin %i) received hotplug event.\n",
-				      connector->name, intel_encoder->hpd_pin);
-		}
 	}
 	 /* if there were no outputs to poll, poll was disabled,
 	  * therefore make sure it's enabled when disabling HPD on
@@ -939,6 +935,8 @@ static void i915_hotplug_work_func(struct work_struct *work)
 			continue;
 		intel_encoder = intel_connector->encoder;
 		if (hpd_event_bits & (1 << intel_encoder->hpd_pin)) {
+			DRM_DEBUG_KMS("Connector %s (pin %i) received hotplug event.\n",
+				      connector->name, intel_encoder->hpd_pin);
 			if (intel_encoder->hot_plug)
 				intel_encoder->hot_plug(intel_encoder);
 			if (intel_hpd_irq_event(dev, connector))