arm64: unify idmap removal

We currently open-code the removal of the idmap and restoration of the
current task's MMU state in a few places.

Before introducing yet more copies of this sequence, unify these to call
a new helper, cpu_uninstall_idmap.
Signed-off-by: NMark Rutland <mark.rutland@arm.com>
Reviewed-by: NCatalin Marinas <catalin.marinas@arm.com>
Tested-by: NArd Biesheuvel <ard.biesheuvel@linaro.org>
Reviewed-by: NArd Biesheuvel <ard.biesheuvel@linaro.org>
Tested-by: NJeremy Linton <jeremy.linton@arm.com>
Cc: Laura Abbott <labbott@fedoraproject.org>
Cc: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Cc: Will Deacon <will.deacon@arm.com>
Signed-off-by: NCatalin Marinas <catalin.marinas@arm.com>

arch/arm64/include/asm/mmu_context.h

@@ -27,6 +27,7 @@
 #include <asm-generic/mm_hooks.h>
 #include <asm/cputype.h>
 #include <asm/pgtable.h>
+#include <asm/tlbflush.h>
 
 #ifdef CONFIG_PID_IN_CONTEXTIDR
 static inline void contextidr_thread_switch(struct task_struct *next)
@@ -89,6 +90,30 @@ static inline void cpu_set_default_tcr_t0sz(void)
 	: "r"(TCR_T0SZ(VA_BITS)), "I"(TCR_T0SZ_OFFSET), "I"(TCR_TxSZ_WIDTH));
 }
 
+/*
+ * Remove the idmap from TTBR0_EL1 and install the pgd of the active mm.
+ *
+ * The idmap lives in the same VA range as userspace, but uses global entries
+ * and may use a different TCR_EL1.T0SZ. To avoid issues resulting from
+ * speculative TLB fetches, we must temporarily install the reserved page
+ * tables while we invalidate the TLBs and set up the correct TCR_EL1.T0SZ.
+ *
+ * If current is a not a user task, the mm covers the TTBR1_EL1 page tables,
+ * which should not be installed in TTBR0_EL1. In this case we can leave the
+ * reserved page tables in place.
+ */
+static inline void cpu_uninstall_idmap(void)
+{
+	struct mm_struct *mm = current->active_mm;
+
+	cpu_set_reserved_ttbr0();
+	local_flush_tlb_all();
+	cpu_set_default_tcr_t0sz();
+
+	if (mm != &init_mm)
+		cpu_switch_mm(mm->pgd, mm);
+}
+
 /*
  * It would be nice to return ASIDs back to the allocator, but unfortunately
  * that introduces a race with a generation rollover where we could erroneously

arch/arm64/kernel/setup.c

@@ -62,6 +62,7 @@
 #include <asm/memblock.h>
 #include <asm/efi.h>
 #include <asm/xen/hypervisor.h>
+#include <asm/mmu_context.h>
 
 phys_addr_t __fdt_pointer __initdata;
 

arch/arm64/kernel/smp.c

@@ -149,9 +149,7 @@ asmlinkage void secondary_start_kernel(void)
 	 * TTBR0 is only used for the identity mapping at this stage. Make it
 	 * point to zero page to avoid speculatively fetching new entries.
 	 */
-	cpu_set_reserved_ttbr0();
-	local_flush_tlb_all();
-	cpu_set_default_tcr_t0sz();
+	cpu_uninstall_idmap();
 
 	preempt_disable();
 	trace_hardirqs_off();

arch/arm64/kernel/suspend.c

@@ -60,7 +60,6 @@ void __init cpu_suspend_set_dbg_restorer(void (*hw_bp_restore)(void *))
  */
 int cpu_suspend(unsigned long arg, int (*fn)(unsigned long))
 {
-	struct mm_struct *mm = current->active_mm;
 	int ret;
 	unsigned long flags;
 
@@ -87,22 +86,11 @@ int cpu_suspend(unsigned long arg, int (*fn)(unsigned long))
 	ret = __cpu_suspend_enter(arg, fn);
 	if (ret == 0) {
 		/*
-		 * We are resuming from reset with TTBR0_EL1 set to the
-		 * idmap to enable the MMU; set the TTBR0 to the reserved
-		 * page tables to prevent speculative TLB allocations, flush
-		 * the local tlb and set the default tcr_el1.t0sz so that
-		 * the TTBR0 address space set-up is properly restored.
-		 * If the current active_mm != &init_mm we entered cpu_suspend
-		 * with mappings in TTBR0 that must be restored, so we switch
-		 * them back to complete the address space configuration
-		 * restoration before returning.
+		 * We are resuming from reset with the idmap active in TTBR0_EL1.
+		 * We must uninstall the idmap and restore the expected MMU
+		 * state before we can possibly return to userspace.
 		 */
-		cpu_set_reserved_ttbr0();
-		local_flush_tlb_all();
-		cpu_set_default_tcr_t0sz();
-
-		if (mm != &init_mm)
-			cpu_switch_mm(mm->pgd, mm);
+		cpu_uninstall_idmap();
 
 		/*
 		 * Restore per-cpu offset before any kernel

arch/arm64/mm/mmu.c

@@ -468,9 +468,7 @@ void __init paging_init(void)
 	 * TTBR0 is only used for the identity mapping at this stage. Make it
 	 * point to zero page to avoid speculatively fetching new entries.
 	 */
-	cpu_set_reserved_ttbr0();
-	local_flush_tlb_all();
-	cpu_set_default_tcr_t0sz();
+	cpu_uninstall_idmap();
 }
 
 /*