提交 9cf4f298 编写于 作者: G Glauber Costa 提交者: Ingo Molnar

x86: use stack_start in x86_64

call x86_64's init_rsp stack_start, just as i386 does.
Put a zeroed stack segment for consistency. With this,
we can eliminate one ugly ifdef in smpboot.c.
Signed-off-by: NGlauber Costa <gcosta@redhat.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>
上级 a7bf0bd5
......@@ -86,7 +86,7 @@ int acpi_save_state_mem(void)
saved_magic = 0x12345678;
#else /* CONFIG_64BIT */
header->trampoline_segment = setup_trampoline() >> 4;
init_rsp = (unsigned long)temp_stack + 4096;
stack_start.sp = temp_stack + 4096;
initial_code = (unsigned long)wakeup_long64;
saved_magic = 0x123456789abcdef0;
#endif /* CONFIG_64BIT */
......
......@@ -191,7 +191,7 @@ ENTRY(secondary_startup_64)
movq %rax, %cr0
/* Setup a boot time stack */
movq init_rsp(%rip),%rsp
movq stack_start(%rip),%rsp
/* zero EFLAGS after setting rsp */
pushq $0
......@@ -252,8 +252,9 @@ ENTRY(secondary_startup_64)
.quad x86_64_start_kernel
__FINITDATA
ENTRY(init_rsp)
ENTRY(stack_start)
.quad init_thread_union+THREAD_SIZE-8
.word 0
bad_address:
jmp bad_address
......
......@@ -714,11 +714,7 @@ wakeup_secondary_cpu(int phys_apicid, unsigned long start_eip)
* target processor state.
*/
startup_ipi_hook(phys_apicid, (unsigned long) start_secondary,
#ifdef CONFIG_X86_64
(unsigned long)init_rsp);
#else
(unsigned long)stack_start.sp);
#endif
/*
* Run STARTUP IPI loop.
......@@ -905,15 +901,14 @@ static int __cpuinit do_boot_cpu(int apicid, int cpu)
early_gdt_descr.address = (unsigned long)get_cpu_gdt_table(cpu);
c_idle.idle->thread.ip = (unsigned long) start_secondary;
/* Stack for startup_32 can be just as for start_secondary onwards */
stack_start.sp = (void *) c_idle.idle->thread.sp;
irq_ctx_init(cpu);
#else
cpu_pda(cpu)->pcurrent = c_idle.idle;
init_rsp = c_idle.idle->thread.sp;
load_sp0(&per_cpu(init_tss, cpu), &c_idle.idle->thread);
initial_code = (unsigned long)start_secondary;
clear_tsk_thread_flag(c_idle.idle, TIF_FORK);
#endif
stack_start.sp = (void *) c_idle.idle->thread.sp;
/* start_ip had better be page-aligned! */
start_ip = setup_trampoline();
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册