macb: fix PHY reset

The driver calls gpiod_set_value() with GPIOD_OUT_* instead of 0 and 1, as
a result the PHY isn't really  put back into reset state in macb_remove().
Moreover, the driver assumes that something else has set the GPIO direction
to output, so if  it has not, the PHY may not be taken out of reset in
macb_probe() either...
Signed-off-by: NSergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/ethernet/cadence/macb.c

@@ -2959,7 +2959,7 @@ static int macb_probe(struct platform_device *pdev)
 		int gpio = of_get_named_gpio(phy_node, "reset-gpios", 0);
 		if (gpio_is_valid(gpio))
 			bp->reset_gpio = gpio_to_desc(gpio);
-		gpiod_set_value(bp->reset_gpio, GPIOD_OUT_HIGH);
+		gpiod_direction_output(bp->reset_gpio, 1);
 	}
 	of_node_put(phy_node);
 
@@ -3029,7 +3029,7 @@ static int macb_remove(struct platform_device *pdev)
 		mdiobus_free(bp->mii_bus);
 
 		/* Shutdown the PHY if there is a GPIO reset */
-		gpiod_set_value(bp->reset_gpio, GPIOD_OUT_LOW);
+		gpiod_set_value(bp->reset_gpio, 0);
 
 		unregister_netdev(dev);
 		clk_disable_unprepare(bp->tx_clk);