提交 97d60162 编写于 作者: P Paul Walmsley

OMAP: hwmod: allow omap_hwmod_late_init() caller to skip module idle in _setup()

On kernels that don't use the omap_device_enable() calls to enable
devices, leave all on-chip devices enabled in hwmod _setup().
Otherwise, accesses to those devices are likely to fail, crashing the
system.  It's expected that kernels built without CONFIG_PM_RUNTIME
will be the primary use-case for this.  This functionality is
controlled by adding an extra parameter to omap_hwmod_late_init().

This patch is based on the patch "OMAP: hwmod: don't auto-disable
hwmod when !CONFIG_PM_RUNTIME" by Kevin Hilman
<khilman@deeprootsystems.com>.

Cc: Kevin Hilman <khilman@deeprootsystems.com>
Signed-off-by: NPaul Walmsley <paul@pwsan.com>
上级 84824022
......@@ -316,6 +316,8 @@ static int __init _omap2_init_reprogram_sdrc(void)
void __init omap2_init_common_hw(struct omap_sdrc_params *sdrc_cs0,
struct omap_sdrc_params *sdrc_cs1)
{
u8 skip_setup_idle = 0;
pwrdm_init(powerdomains_omap);
clkdm_init(clockdomains_omap, clkdm_autodeps);
if (cpu_is_omap242x())
......@@ -340,8 +342,13 @@ void __init omap2_init_common_hw(struct omap_sdrc_params *sdrc_cs0,
pr_err("Could not init clock framework - unknown CPU\n");
omap_serial_early_init();
#ifndef CONFIG_PM_RUNTIME
skip_setup_idle = 1;
#endif
if (cpu_is_omap24xx() || cpu_is_omap34xx()) /* FIXME: OMAP4 */
omap_hwmod_late_init();
omap_hwmod_late_init(skip_setup_idle);
omap_pm_if_init();
if (cpu_is_omap24xx() || cpu_is_omap34xx()) {
omap2_sdrc_init(sdrc_cs0, sdrc_cs1);
......
......@@ -764,6 +764,7 @@ static struct omap_hwmod *_lookup(const char *name)
/**
* _init_clocks - clk_get() all clocks associated with this hwmod
* @oh: struct omap_hwmod *
* @data: not used; pass NULL
*
* Called by omap_hwmod_late_init() (after omap2_clk_init()).
* Resolves all clock names embedded in the hwmod. Must be called
......@@ -771,7 +772,7 @@ static struct omap_hwmod *_lookup(const char *name)
* has not yet been registered or if the clocks have already been
* initialized, 0 on success, or a non-zero error on failure.
*/
static int _init_clocks(struct omap_hwmod *oh)
static int _init_clocks(struct omap_hwmod *oh, void *data)
{
int ret = 0;
......@@ -996,19 +997,25 @@ static int _shutdown(struct omap_hwmod *oh)
/**
* _setup - do initial configuration of omap_hwmod
* @oh: struct omap_hwmod *
* @skip_setup_idle_p: do not idle hwmods at the end of the fn if 1
*
* Writes the CLOCKACTIVITY bits @clockact to the hwmod @oh
* OCP_SYSCONFIG register. Must be called with omap_hwmod_mutex
* held. Returns -EINVAL if the hwmod is in the wrong state or returns
* 0.
* OCP_SYSCONFIG register. Must be called with omap_hwmod_mutex held.
* @skip_setup_idle is intended to be used on a system that will not
* call omap_hwmod_enable() to enable devices (e.g., a system without
* PM runtime). Returns -EINVAL if the hwmod is in the wrong state or
* returns 0.
*/
static int _setup(struct omap_hwmod *oh)
static int _setup(struct omap_hwmod *oh, void *data)
{
int i, r;
u8 skip_setup_idle;
if (!oh)
if (!oh || !data)
return -EINVAL;
skip_setup_idle = *(u8 *)data;
/* Set iclk autoidle mode */
if (oh->slaves_cnt > 0) {
for (i = 0; i < oh->slaves_cnt; i++) {
......@@ -1050,7 +1057,7 @@ static int _setup(struct omap_hwmod *oh)
}
}
if (!(oh->flags & HWMOD_INIT_NO_IDLE))
if (!(oh->flags & HWMOD_INIT_NO_IDLE) && !skip_setup_idle)
_omap_hwmod_idle(oh);
return 0;
......@@ -1164,6 +1171,7 @@ struct omap_hwmod *omap_hwmod_lookup(const char *name)
/**
* omap_hwmod_for_each - call function for each registered omap_hwmod
* @fn: pointer to a callback function
* @data: void * data to pass to callback function
*
* Call @fn for each registered omap_hwmod, passing @data to each
* function. @fn must return 0 for success or any other value for
......@@ -1172,7 +1180,8 @@ struct omap_hwmod *omap_hwmod_lookup(const char *name)
* caller of omap_hwmod_for_each(). @fn is called with
* omap_hwmod_for_each() held.
*/
int omap_hwmod_for_each(int (*fn)(struct omap_hwmod *oh))
int omap_hwmod_for_each(int (*fn)(struct omap_hwmod *oh, void *data),
void *data)
{
struct omap_hwmod *temp_oh;
int ret;
......@@ -1182,7 +1191,7 @@ int omap_hwmod_for_each(int (*fn)(struct omap_hwmod *oh))
mutex_lock(&omap_hwmod_mutex);
list_for_each_entry(temp_oh, &omap_hwmod_list, node) {
ret = (*fn)(temp_oh);
ret = (*fn)(temp_oh, data);
if (ret)
break;
}
......@@ -1229,24 +1238,28 @@ int omap_hwmod_init(struct omap_hwmod **ohs)
/**
* omap_hwmod_late_init - do some post-clock framework initialization
* @skip_setup_idle: if 1, do not idle hwmods in _setup()
*
* Must be called after omap2_clk_init(). Resolves the struct clk names
* to struct clk pointers for each registered omap_hwmod. Also calls
* _setup() on each hwmod. Returns 0.
*/
int omap_hwmod_late_init(void)
int omap_hwmod_late_init(u8 skip_setup_idle)
{
int r;
/* XXX check return value */
r = omap_hwmod_for_each(_init_clocks);
r = omap_hwmod_for_each(_init_clocks, NULL);
WARN(r, "omap_hwmod: omap_hwmod_late_init(): _init_clocks failed\n");
mpu_oh = omap_hwmod_lookup(MPU_INITIATOR_NAME);
WARN(!mpu_oh, "omap_hwmod: could not find MPU initiator hwmod %s\n",
MPU_INITIATOR_NAME);
omap_hwmod_for_each(_setup);
if (skip_setup_idle)
pr_debug("omap_hwmod: will leave hwmods enabled during setup\n");
omap_hwmod_for_each(_setup, &skip_setup_idle);
return 0;
}
......
......@@ -482,8 +482,9 @@ int omap_hwmod_init(struct omap_hwmod **ohs);
int omap_hwmod_register(struct omap_hwmod *oh);
int omap_hwmod_unregister(struct omap_hwmod *oh);
struct omap_hwmod *omap_hwmod_lookup(const char *name);
int omap_hwmod_for_each(int (*fn)(struct omap_hwmod *oh));
int omap_hwmod_late_init(void);
int omap_hwmod_for_each(int (*fn)(struct omap_hwmod *oh, void *data),
void *data);
int omap_hwmod_late_init(u8 skip_setup_idle);
int omap_hwmod_enable(struct omap_hwmod *oh);
int _omap_hwmod_enable(struct omap_hwmod *oh);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册