PCI: read current power state at enable time

When we enable a PCI device, we avoid doing a lot of the initial setup
work if the device's enable count is non-zero.  If we don't fetch the
power state though, we may later fail to set up MSI due to the unknown
status.  So pick it up before we short circuit the rest due to a
pre-existing enable or mismatched enable/disable pair (as happens with
VGA devices, which are special in a special way).
Tested-by: NJesse Brandeburg <jesse.brandeburg@gmail.com>
Reported-by: NDave Airlie <airlied@linux.ie>
Tested-by: NDave Airlie <airlied@linux.ie>
Signed-off-by: NJesse Barnes <jbarnes@virtuousgeek.org>

drivers/pci/pci.c

@@ -1007,6 +1007,18 @@ static int __pci_enable_device_flags(struct pci_dev *dev,
 	int err;
 	int i, bars = 0;
 
+	/*
+	 * Power state could be unknown at this point, either due to a fresh
+	 * boot or a device removal call.  So get the current power state
+	 * so that things like MSI message writing will behave as expected
+	 * (e.g. if the device really is in D0 at enable time).
+	 */
+	if (dev->pm_cap) {
+		u16 pmcsr;
+		pci_read_config_word(dev, dev->pm_cap + PCI_PM_CTRL, &pmcsr);
+		dev->current_state = (pmcsr & PCI_PM_CTRL_STATE_MASK);
+	}
+
 	if (atomic_add_return(1, &dev->enable_cnt) > 1)
 		return 0;		/* already enabled */