spi/bfin_spi: sync hardware state before reprogramming everything

Sometimes under load, the Blackfin core is able to send SPI register
updates out before the controller is actually disabled.  So when we
go to reprogram the entire state (to switch to a different slave),
make sure we sync after disabling the controller.
Signed-off-by: NBarry Song <barry.song@analog.com>
Signed-off-by: NMike Frysinger <vapier@gentoo.org>

drivers/spi/spi_bfin5xx.c

@@ -247,6 +247,8 @@ static void bfin_spi_restore_state(struct master_data *drv_data)
 	bfin_spi_disable(drv_data);
 	dev_dbg(&drv_data->pdev->dev, "restoring spi ctl state\n");
 
+	SSYNC();
+
 	/* Load the registers */
 	write_CTRL(drv_data, chip->ctl_reg);
 	write_BAUD(drv_data, chip->baud);