V4L/DVB (4495): Fix "no data from ZL10353 based USB tuner" problem

Force parallel transport stream output on the ZL10353 attached to a
bluebird device.
Addresses the problem where a frontend lock was observed, but no MPEG
transport data was received.
Signed-off-by: NChris Pascoe <c.pascoe@itee.uq.edu.au>
Signed-off-by: NMauro Carvalho Chehab <mchehab@infradead.org>

drivers/media/dvb/dvb-usb/cxusb.c

@@ -349,6 +349,7 @@ static struct mt352_config cxusb_dee1601_config = {
 
 static struct zl10353_config cxusb_zl10353_dee1601_config = {
 	.demod_address = 0x0f,
+	.parallel_ts = 1,
 };
 
 static struct mt352_config cxusb_mt352_config = {

drivers/media/dvb/frontends/zl10353.c

@@ -243,9 +243,12 @@ static int zl10353_init(struct dvb_frontend *fe)
 
 	if (debug_regs)
 		zl10353_dump_regs(fe);
+	if (state->config.parallel_ts)
+		zl10353_reset_attach[2] &= ~0x20;
 
 	/* Do a "hard" reset if not already done */
-	if (zl10353_read_register(state, 0x50) != 0x03) {
+	if (zl10353_read_register(state, 0x50) != zl10353_reset_attach[1] ||
+	    zl10353_read_register(state, 0x51) != zl10353_reset_attach[2]) {
 		rc = zl10353_write(fe, zl10353_reset_attach,
 				   sizeof(zl10353_reset_attach));
 		if (debug_regs)

drivers/media/dvb/frontends/zl10353.h

@@ -31,6 +31,9 @@ struct zl10353_config
 
 	/* set if no pll is connected to the secondary i2c bus */
 	int no_tuner;
+
+	/* set if parallel ts output is required */
+	int parallel_ts;
 };
 
 #if defined(CONFIG_DVB_ZL10353) || defined(CONFIG_DVB_ZL10353_MODULE)