提交 8cf5858c 编写于 作者: V Vitja Makarov 提交者: Linus Torvalds

Blackfin SPI Driver: ensure cache coherency before doing DMA

Flush or invalidate caches before doing DMA transfer, if needed.

[Mike Frysinger <vapier.adi@gmail.com>: add comment to address the
issue "Full duplex only works for non-DMA transfers".]
Signed-off-by: NVitja Makarov <vitja.makarov@gmail.com>
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com>
Signed-off-by: NBryan Wu <cooloney@kernel.org>
Cc: David Brownell <david-b@pacbell.net>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
上级 3bcfa9e4
......@@ -26,6 +26,10 @@
#include <asm/portmux.h>
#include <asm/bfin5xx_spi.h>
/* reserved_mem_dcache_on and cache friends */
#include <asm/cplbinit.h>
#include <asm/cacheflush.h>
#define DRV_NAME "bfin-spi"
#define DRV_AUTHOR "Bryan Wu, Luke Yang"
#define DRV_DESC "Blackfin BF5xx on-chip SPI Controller Driver"
......@@ -738,9 +742,10 @@ static void pump_transfers(unsigned long data)
width, transfer->len);
/*
* Try to map dma buffer and do a dma transfer if
* successful use different way to r/w according to
* drv_data->cur_chip->enable_dma
* Try to map dma buffer and do a dma transfer. If successful use,
* different way to r/w according to the enable_dma settings and if
* we are not doing a full duplex transfer (since the hardware does
* not support full duplex DMA transfers).
*/
if (!full_duplex && drv_data->cur_chip->enable_dma
&& drv_data->len > 6) {
......@@ -795,6 +800,12 @@ static void pump_transfers(unsigned long data)
/* set transfer mode, and enable SPI */
dev_dbg(&drv_data->pdev->dev, "doing DMA in.\n");
/* invalidate caches, if needed */
if (bfin_addr_dcachable((unsigned long) drv_data->rx))
invalidate_dcache_range((unsigned long) drv_data->rx,
(unsigned long) (drv_data->rx +
drv_data->len));
/* clear tx reg soformer data is not shifted out */
write_TDBR(drv_data, 0xFFFF);
......@@ -815,6 +826,12 @@ static void pump_transfers(unsigned long data)
} else if (drv_data->tx != NULL) {
dev_dbg(&drv_data->pdev->dev, "doing DMA out.\n");
/* flush caches, if needed */
if (bfin_addr_dcachable((unsigned long) drv_data->tx))
flush_dcache_range((unsigned long) drv_data->tx,
(unsigned long) (drv_data->tx +
drv_data->len));
/* start dma */
dma_enable_irq(drv_data->dma_channel);
dma_config = (RESTART | dma_width | DI_EN);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册