ath5k: enable Power-Save Polls by setting the association ID

mac80211 has long provided us the association ID. This isn't useful except
for Power-Save polling which now gets enabled. We can now poll for our
pending frames on the AP during power save.

You can review the details of Power-Save on the wireless wiki:

http://wireless.kernel.org/en/developers/Documentation/ieee80211/power-savingsSigned-off-by: NLuis R. Rodriguez <lrodriguez@atheros.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

drivers/net/wireless/ath/ath5k/base.c

@@ -3211,8 +3211,7 @@ static void ath5k_bss_info_changed(struct ieee80211_hw *hw,
 	if (changes & BSS_CHANGED_BSSID) {
 		/* Cache for later use during resets */
 		memcpy(common->curbssid, bss_conf->bssid, ETH_ALEN);
-		/* XXX: assoc id is set to 0 for now, mac80211 doesn't have
-		 * a clean way of letting us retrieve this yet. */
+		common->curaid = 0;
 		ath5k_hw_set_associd(ah);
 		mmiowb();
 	}
@@ -3226,6 +3225,14 @@ static void ath5k_bss_info_changed(struct ieee80211_hw *hw,
 			set_beacon_filter(hw, sc->assoc);
 		ath5k_hw_set_ledstate(sc->ah, sc->assoc ?
 			AR5K_LED_ASSOC : AR5K_LED_INIT);
+		if (bss_conf->assoc) {
+			ATH5K_DBG(sc, ATH5K_DEBUG_ANY,
+				  "Bss Info ASSOC %d, bssid: %pM\n",
+				  bss_conf->aid, common->curbssid);
+			common->curaid = bss_conf->aid;
+			ath5k_hw_set_associd(ah);
+			/* Once ANI is available you would start it here */
+		}
 	}
 
 	if (changes & BSS_CHANGED_BEACON) {

drivers/net/wireless/ath/ath5k/reset.c

@@ -1187,7 +1187,6 @@ int ath5k_hw_reset(struct ath5k_hw *ah, enum nl80211_iftype op_mode,
 	 */
 
 	/* Restore bssid and bssid mask */
-	/* XXX: add ah->aid once mac80211 gives this to us */
 	ath5k_hw_set_associd(ah);
 
 	/* Set PCU config */