提交 85c10f28 编写于 作者: R Rob Herring 提交者: David S. Miller

net: add calxeda xgmac ethernet driver

Add support for the XGMAC 10Gb ethernet device in the Calxeda Highbank
SOC.
Signed-off-by: NRob Herring <rob.herring@calxeda.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
上级 8ac72d16
* Calxeda Highbank 10Gb XGMAC Ethernet
Required properties:
- compatible : Should be "calxeda,hb-xgmac"
- reg : Address and length of the register set for the device
- interrupts : Should contain 3 xgmac interrupts. The 1st is main interrupt.
The 2nd is pwr mgt interrupt. The 3rd is low power state interrupt.
Example:
ethernet@fff50000 {
compatible = "calxeda,hb-xgmac";
reg = <0xfff50000 0x1000>;
interrupts = <0 77 4 0 78 4 0 79 4>;
};
......@@ -28,6 +28,7 @@ source "drivers/net/ethernet/cadence/Kconfig"
source "drivers/net/ethernet/adi/Kconfig"
source "drivers/net/ethernet/broadcom/Kconfig"
source "drivers/net/ethernet/brocade/Kconfig"
source "drivers/net/ethernet/calxeda/Kconfig"
source "drivers/net/ethernet/chelsio/Kconfig"
source "drivers/net/ethernet/cirrus/Kconfig"
source "drivers/net/ethernet/cisco/Kconfig"
......
......@@ -14,6 +14,7 @@ obj-$(CONFIG_NET_ATMEL) += cadence/
obj-$(CONFIG_NET_BFIN) += adi/
obj-$(CONFIG_NET_VENDOR_BROADCOM) += broadcom/
obj-$(CONFIG_NET_VENDOR_BROCADE) += brocade/
obj-$(CONFIG_NET_CALXEDA_XGMAC) += calxeda/
obj-$(CONFIG_NET_VENDOR_CHELSIO) += chelsio/
obj-$(CONFIG_NET_VENDOR_CIRRUS) += cirrus/
obj-$(CONFIG_NET_VENDOR_CISCO) += cisco/
......
config NET_CALXEDA_XGMAC
tristate "Calxeda 1G/10G XGMAC Ethernet driver"
select CRC32
help
This is the driver for the XGMAC Ethernet IP block found on Calxeda
Highbank platforms.
obj-$(CONFIG_NET_CALXEDA_XGMAC) += xgmac.o
此差异已折叠。
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册