提交 839da4d9 编写于 作者: D David Ahern 提交者: David S. Miller

net: ipv4: set orig_oif based on fib result for local traffic

Attempts to connect to a local address with a socket bound
to a device with the local address hangs if there is no listener:

  $ ip addr sh dev eth1
  3: eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
    link/ether 02:e0:f9:1c:00:37 brd ff:ff:ff:ff:ff:ff
    inet 10.100.1.4/24 scope global eth1
       valid_lft forever preferred_lft forever
    inet6 2001:db8:1::4/120 scope global
       valid_lft forever preferred_lft forever
    inet6 fe80::e0:f9ff:fe1c:37/64 scope link
       valid_lft forever preferred_lft forever

  $ vrf-test -I eth1 -r 10.100.1.4
  <hangs when there is no server>

(don't let the command name fool you; vrf-test works without vrfs.)

The problem is that the original intended device, eth1 in this case, is
lost when the tcp reset is sent, so the socket lookup does not find a
match for the reset and the connect attempt hangs. Fix by adjusting
orig_oif for local traffic to the device from the fib lookup result.

With this patch you get the more user friendly:
  $ vrf-test -I eth1 -r 10.100.1.4
  connect failed: 111: Connection refused

orig_oif is saved to the newly created rtable as rt_iif and when set
it is used as the dif for socket lookups. It is set based on flowi4_oif
passed in to ip_route_output_key_hash_rcu and will be set to either
the loopback device, an l3mdev device, nothing (flowi4_oif = 0 which
is the case in the example above) or a netdev index depending on the
lookup path. In each case, resetting orig_oif to the device in the fib
result for the RTN_LOCAL case allows the actual device to be preserved
as the skb tx and rx is done over the loopback or VRF device.
Signed-off-by: NDavid Ahern <dsahern@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
上级 e37425c2
......@@ -2439,6 +2439,12 @@ struct rtable *ip_route_output_key_hash_rcu(struct net *net, struct flowi4 *fl4,
/* L3 master device is the loopback for that domain */
dev_out = l3mdev_master_dev_rcu(FIB_RES_DEV(*res)) ? :
net->loopback_dev;
/* make sure orig_oif points to fib result device even
* though packet rx/tx happens over loopback or l3mdev
*/
orig_oif = FIB_RES_OIF(*res);
fl4->flowi4_oif = dev_out->ifindex;
flags |= RTCF_LOCAL;
goto make_route;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册