iwlwifi: pcie: use WFPM_GP for debugging D3 flows

This register is helpful for debugging D3 issues.
Driver turns all bits on, and then on exit reads the
updated value there.
Signed-off-by: NSara Sharon <sara.sharon@intel.com>
Signed-off-by: NLuca Coelho <luciano.coelho@intel.com>

drivers/net/wireless/intel/iwlwifi/iwl-prph.h

@@ -378,6 +378,7 @@
 #define RADIO_REG_SYS_MANUAL_DFT_0	0xAD4078
 #define RFIC_REG_RD			0xAD0470
 #define WFPM_CTRL_REG			0xA03030
+#define WFPM_GP2			0xA030B4
 enum {
 	ENABLE_WFPM = BIT(31),
 	WFPM_AUX_CTL_AUX_IF_MAC_OWNER_MSK	= 0x80000000,

drivers/net/wireless/intel/iwlwifi/pcie/trans.c

@@ -1047,6 +1047,16 @@ static int iwl_pcie_load_given_ucode_8000(struct iwl_trans *trans,
 	if (ret)
 		return ret;
 
+	IWL_DEBUG_POWER(trans, "Original WFPM value = 0x%08X\n",
+			iwl_read_prph(trans, WFPM_GP2));
+
+	/*
+	 * Set default value. On resume reading the values that were
+	 * zeored can provide debug data on the resume flow.
+	 * This is for debugging only and has no functional impact.
+	 */
+	iwl_write_prph(trans, WFPM_GP2, 0x01010101);
+
 	/* configure the ucode to be ready to get the secured image */
 	/* release CPU reset */
 	iwl_write_prph(trans, RELEASE_CPU_RESET, RELEASE_CPU_RESET_BIT);
@@ -1527,6 +1537,9 @@ static int iwl_trans_pcie_d3_resume(struct iwl_trans *trans,
 		}
 	}
 
+	IWL_DEBUG_POWER(trans, "WFPM value upon resume = 0x%08X\n",
+			iwl_read_prph(trans, WFPM_GP2));
+
 	val = iwl_read32(trans, CSR_RESET);
 	if (val & CSR_RESET_REG_FLAG_NEVO_RESET)
 		*status = IWL_D3_STATUS_RESET;