[PATCH] pci: initialize struct pci_dev.error_state

The pci channel state is currently uninitialized, thus there are two ways
of indicating that "everything's OK": 0 and 1.  This is a bit of a burden.

If a devce driver wants to check if the pci channel is in a working or a
disconnected state, the driver writer must perform checks similar to

   if((pdev->error_state != 0) &&
      (pdev->error_state != pci_channel_io_normal)) {
         whatever();
   }

which is rather akward.  The first check is needed because stuct pci_dev is
inited to all-zeros.  The scond is needed because the error recovery will
set the state to pci_channel_io_normal (which is not zero).

This patch fixes this awkwardness.
Signed-off-by: NLinas Vepstas <linas@austin.ibm.com>
Cc: Greg KH <greg@kroah.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

drivers/pci/probe.c

@@ -815,6 +815,7 @@ pci_scan_device(struct pci_bus *bus, int devfn)
 	dev->vendor = l & 0xffff;
 	dev->device = (l >> 16) & 0xffff;
 	dev->cfg_size = pci_cfg_space_size(dev);
+	dev->error_state = pci_channel_io_normal;
 
 	/* Assume 32-bit PCI; let 64-bit PCI cards (which are far rarer)
 	   set this higher, assuming the system even supports it.  */