提交 811a1882 编写于 作者: L Linus Walleij

gpio: menz127: use the new open drain callback

The menz127 driver tries to support open drain by detecting it
at request time. However: without the new callbacks from the
gpiolib it is not really working: the core will still just emulate
the open drain mode by switching the line to an input.

By adding a hook into the new .set_single_ended() call rather than
trying to autodetect at request() time, proper open drain can be
supported.

Cc: Andreas Werner <andy@wernerandy.de>
Signed-off-by: NLinus Walleij <linus.walleij@linaro.org>
上级 f90c6bdb
......@@ -88,21 +88,25 @@ static int men_z127_debounce(struct gpio_chip *gc, unsigned gpio,
return 0;
}
static int men_z127_request(struct gpio_chip *gc, unsigned gpio_pin)
static int men_z127_set_single_ended(struct gpio_chip *gc,
unsigned offset,
enum single_ended_mode mode)
{
struct men_z127_gpio *priv = gpiochip_get_data(gc);
u32 od_en;
if (gpio_pin >= gc->ngpio)
return -EINVAL;
if (mode != LINE_MODE_OPEN_DRAIN &&
mode != LINE_MODE_PUSH_PULL)
return -ENOTSUPP;
spin_lock(&priv->lock);
od_en = readl(priv->reg_base + MEN_Z127_ODER);
if (gpiochip_line_is_open_drain(gc, gpio_pin))
od_en |= BIT(gpio_pin);
if (mode == LINE_MODE_OPEN_DRAIN)
od_en |= BIT(offset);
else
od_en &= ~BIT(gpio_pin);
/* Implicitly LINE_MODE_PUSH_PULL */
od_en &= ~BIT(offset);
writel(od_en, priv->reg_base + MEN_Z127_ODER);
spin_unlock(&priv->lock);
......@@ -147,7 +151,7 @@ static int men_z127_probe(struct mcb_device *mdev,
goto err_unmap;
men_z127_gpio->gc.set_debounce = men_z127_debounce;
men_z127_gpio->gc.request = men_z127_request;
men_z127_gpio->gc.set_single_ended = men_z127_set_single_ended;
ret = gpiochip_add_data(&men_z127_gpio->gc, men_z127_gpio);
if (ret) {
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册