提交 80323742 编写于 作者: R Roger Quadros

ARM: OMAP2+: gpmc: Print error message in set_gpmc_timing_reg()

Simplify set_gpmc_timing_reg() and always print error message
if the requested timing cannot be achieved due to a too fast
GPMC functional clock, irrespective if whether DEBUG is defined
or not. This should help us debug timing configuration issues,
which were otherwise simply not being displayed in the kernel log.
Signed-off-by: NRoger Quadros <rogerq@ti.com>
Signed-off-by: NSekhar Nori <nsekhar@ti.com>
Acked-by: NTony Lindgren <tony@atomide.com>
上级 f114040e
......@@ -283,13 +283,8 @@ static void gpmc_cs_bool_timings(int cs, const struct gpmc_bool_timings *p)
p->cycle2cyclediffcsen);
}
#ifdef DEBUG
static int set_gpmc_timing_reg(int cs, int reg, int st_bit, int end_bit,
int time, const char *name)
#else
static int set_gpmc_timing_reg(int cs, int reg, int st_bit, int end_bit,
int time)
#endif
{
u32 l;
int ticks, mask, nr_bits;
......@@ -299,15 +294,15 @@ static int set_gpmc_timing_reg(int cs, int reg, int st_bit, int end_bit,
else
ticks = gpmc_ns_to_ticks(time);
nr_bits = end_bit - st_bit + 1;
if (ticks >= 1 << nr_bits) {
#ifdef DEBUG
printk(KERN_INFO "GPMC CS%d: %-10s* %3d ns, %3d ticks >= %d\n",
cs, name, time, ticks, 1 << nr_bits);
#endif
mask = (1 << nr_bits) - 1;
if (ticks > mask) {
pr_err("%s: GPMC error! CS%d: %s: %d ns, %d ticks > %d\n",
__func__, cs, name, time, ticks, mask);
return -1;
}
mask = (1 << nr_bits) - 1;
l = gpmc_cs_read_reg(cs, reg);
#ifdef DEBUG
printk(KERN_INFO
......@@ -322,16 +317,10 @@ static int set_gpmc_timing_reg(int cs, int reg, int st_bit, int end_bit,
return 0;
}
#ifdef DEBUG
#define GPMC_SET_ONE(reg, st, end, field) \
if (set_gpmc_timing_reg(cs, (reg), (st), (end), \
t->field, #field) < 0) \
return -1
#else
#define GPMC_SET_ONE(reg, st, end, field) \
if (set_gpmc_timing_reg(cs, (reg), (st), (end), t->field) < 0) \
return -1
#endif
int gpmc_calc_divider(unsigned int sync_clk)
{
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册