提交 7e995b9e 编写于 作者: M Marcel Holtmann

Bluetooth: Add new quirk for non-persistent diagnostic settings

If the diagnostic settings are not persistent over HCI Reset, then this
quirk can be used to tell the Bluetoth core about it. This will ensure
that the settings are programmed correctly when the controller is
powered up.
Signed-off-by: NMarcel Holtmann <marcel@holtmann.org>
Signed-off-by: NJohan Hedberg <johan.hedberg@intel.com>
上级 7841d06e
......@@ -170,6 +170,15 @@ enum {
* during the hdev->setup vendor callback.
*/
HCI_QUIRK_SIMULTANEOUS_DISCOVERY,
/* When this quirk is set, the enabling of diagnostic mode is
* not persistent over HCI Reset. Every time the controller
* is brought up it needs to be reprogrammed.
*
* This quirk can be set before hci_register_dev is called or
* during the hdev->setup vendor callback.
*/
HCI_QUIRK_NON_PERSISTENT_DIAG,
};
/* HCI device flags */
......
......@@ -162,6 +162,16 @@ static ssize_t vendor_diag_write(struct file *file, const char __user *user_buf,
if (strtobool(buf, &enable))
return -EINVAL;
/* When the diagnostic flags are not persistent and the transport
* is not active, then there is no need for the vendor callback.
*
* Instead just store the desired value. If needed the setting
* will be programmed when the controller gets powered on.
*/
if (test_bit(HCI_QUIRK_NON_PERSISTENT_DIAG, &hdev->quirks) &&
!test_bit(HCI_RUNNING, &hdev->flags))
goto done;
hci_req_lock(hdev);
err = hdev->set_diag(hdev, enable);
hci_req_unlock(hdev);
......@@ -169,6 +179,7 @@ static ssize_t vendor_diag_write(struct file *file, const char __user *user_buf,
if (err < 0)
return err;
done:
if (enable)
hci_dev_set_flag(hdev, HCI_VENDOR_DIAG);
else
......@@ -1494,6 +1505,14 @@ static int hci_dev_do_open(struct hci_dev *hdev)
ret = __hci_init(hdev);
}
/* If the HCI Reset command is clearing all diagnostic settings,
* then they need to be reprogrammed after the init procedure
* completed.
*/
if (test_bit(HCI_QUIRK_NON_PERSISTENT_DIAG, &hdev->quirks) &&
hci_dev_test_flag(hdev, HCI_VENDOR_DIAG) && hdev->set_diag)
ret = hdev->set_diag(hdev, true);
clear_bit(HCI_INIT, &hdev->flags);
if (!ret) {
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册