提交 78841462 编写于 作者: J Jarkko Nikula 提交者: Greg Kroah-Hartman

serial: omap-serial: Enable the UART wake-up bits always

OMAP can do also dynamic idling so wake-up enable register should be set
also while system is running. If UART_OMAP_WER is not set, then for instance
the RX activity cannot wake up the UART port that is sleeping.

This RX wake-up feature was working when the 8250 driver was used instead
of omap-serial. Reason for this is that the 8250 doesn't set the
UART_OMAP_WER and then arch/arm/mach-omap2/pm34xx.c ends up saving and
restoring the reset default which is the same than value
OMAP_UART_WER_MOD_WKUP here.

Fix this by moving the conditional UART_OMAP_WER write from serial_omap_pm
into serial_omap_startup where wake-up bits are set unconditionally.
Signed-off-by: NJarkko Nikula <jhnikula@gmail.com>
Cc: Govindraj.R <govindraj.raja@ti.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
上级 364a6ece
......@@ -520,6 +520,9 @@ static int serial_omap_startup(struct uart_port *port)
up->ier = UART_IER_RLSI | UART_IER_RDI;
serial_out(up, UART_IER, up->ier);
/* Enable module level wake up */
serial_out(up, UART_OMAP_WER, OMAP_UART_WER_MOD_WKUP);
up->port_activity = jiffies;
return 0;
}
......@@ -827,9 +830,6 @@ serial_omap_pm(struct uart_port *port, unsigned int state,
serial_out(up, UART_LCR, UART_LCR_CONF_MODE_B);
serial_out(up, UART_EFR, efr);
serial_out(up, UART_LCR, 0);
/* Enable module level wake up */
serial_out(up, UART_OMAP_WER,
(state != 0) ? OMAP_UART_WER_MOD_WKUP : 0);
}
static void serial_omap_release_port(struct uart_port *port)
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册