iwlwifi: pcie: introduce new stop_device

This function is basically the same as gen1, except for clean
ups of old devices configuration that are never used in a000
configuration.
It will also help with refactoring rf_kill later on.
Signed-off-by: NSara Sharon <sara.sharon@intel.com>
Signed-off-by: NLuca Coelho <luciano.coelho@intel.com>

drivers/net/wireless/intel/iwlwifi/pcie/internal.h

@@ -767,6 +767,8 @@ void iwl_pcie_synchronize_irqs(struct iwl_trans *trans);
 bool iwl_trans_check_hw_rf_kill(struct iwl_trans *trans);
 void iwl_pcie_txq_free_tfd(struct iwl_trans *trans, struct iwl_txq *txq);
 int iwl_queue_space(const struct iwl_txq *q);
+int iwl_pcie_apm_stop_master(struct iwl_trans *trans);
+void iwl_pcie_conf_msix_hw(struct iwl_trans_pcie *trans_pcie);
 
 /* transport gen 2 exported functions */
 int iwl_trans_pcie_gen2_start_fw(struct iwl_trans *trans,
@@ -781,5 +783,8 @@ int iwl_trans_pcie_gen2_tx(struct iwl_trans *trans, struct sk_buff *skb,
 			   struct iwl_device_cmd *dev_cmd, int txq_id);
 int iwl_trans_pcie_gen2_send_hcmd(struct iwl_trans *trans,
 				  struct iwl_host_cmd *cmd);
+void iwl_trans_pcie_gen2_stop_device(struct iwl_trans *trans,
+				     bool low_power);
+void _iwl_trans_pcie_gen2_stop_device(struct iwl_trans *trans, bool low_power);
 
 #endif /* __iwl_trans_int_pcie_h__ */

drivers/net/wireless/intel/iwlwifi/pcie/trans-gen2.c

@@ -111,6 +111,153 @@ static int iwl_pcie_gen2_apm_init(struct iwl_trans *trans)
 	return 0;
 }
 
+static void iwl_pcie_gen2_apm_stop(struct iwl_trans *trans, bool op_mode_leave)
+{
+	IWL_DEBUG_INFO(trans, "Stop card, put in low power state\n");
+
+	if (op_mode_leave) {
+		if (!test_bit(STATUS_DEVICE_ENABLED, &trans->status))
+			iwl_pcie_gen2_apm_init(trans);
+
+		/* inform ME that we are leaving */
+		iwl_set_bit(trans, CSR_DBG_LINK_PWR_MGMT_REG,
+			    CSR_RESET_LINK_PWR_MGMT_DISABLED);
+		iwl_set_bit(trans, CSR_HW_IF_CONFIG_REG,
+			    CSR_HW_IF_CONFIG_REG_PREPARE |
+			    CSR_HW_IF_CONFIG_REG_ENABLE_PME);
+		mdelay(1);
+		iwl_clear_bit(trans, CSR_DBG_LINK_PWR_MGMT_REG,
+			      CSR_RESET_LINK_PWR_MGMT_DISABLED);
+		mdelay(5);
+	}
+
+	clear_bit(STATUS_DEVICE_ENABLED, &trans->status);
+
+	/* Stop device's DMA activity */
+	iwl_pcie_apm_stop_master(trans);
+
+	/* Reset the entire device */
+	iwl_set_bit(trans, CSR_RESET, CSR_RESET_REG_FLAG_SW_RESET);
+	usleep_range(1000, 2000);
+
+	/*
+	 * Clear "initialization complete" bit to move adapter from
+	 * D0A* (powered-up Active) --> D0U* (Uninitialized) state.
+	 */
+	iwl_clear_bit(trans, CSR_GP_CNTRL, CSR_GP_CNTRL_REG_FLAG_INIT_DONE);
+}
+
+void _iwl_trans_pcie_gen2_stop_device(struct iwl_trans *trans, bool low_power)
+{
+	struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
+	bool hw_rfkill, was_hw_rfkill;
+
+	lockdep_assert_held(&trans_pcie->mutex);
+
+	if (trans_pcie->is_down)
+		return;
+
+	trans_pcie->is_down = true;
+
+	was_hw_rfkill = iwl_is_rfkill_set(trans);
+
+	/* tell the device to stop sending interrupts */
+	iwl_disable_interrupts(trans);
+
+	/* device going down, Stop using ICT table */
+	iwl_pcie_disable_ict(trans);
+
+	/*
+	 * If a HW restart happens during firmware loading,
+	 * then the firmware loading might call this function
+	 * and later it might be called again due to the
+	 * restart. So don't process again if the device is
+	 * already dead.
+	 */
+	if (test_and_clear_bit(STATUS_DEVICE_ENABLED, &trans->status)) {
+		IWL_DEBUG_INFO(trans,
+			       "DEVICE_ENABLED bit was set and is now cleared\n");
+		iwl_pcie_tx_stop(trans);
+		iwl_pcie_rx_stop(trans);
+	}
+
+	iwl_pcie_ctxt_info_free_paging(trans);
+	iwl_pcie_ctxt_info_free(trans);
+
+	/* Make sure (redundant) we've released our request to stay awake */
+	iwl_clear_bit(trans, CSR_GP_CNTRL,
+		      CSR_GP_CNTRL_REG_FLAG_MAC_ACCESS_REQ);
+
+	/* Stop the device, and put it in low power state */
+	iwl_pcie_gen2_apm_stop(trans, false);
+
+	/* stop and reset the on-board processor */
+	iwl_write32(trans, CSR_RESET, CSR_RESET_REG_FLAG_SW_RESET);
+	usleep_range(1000, 2000);
+
+	/*
+	 * Upon stop, the IVAR table gets erased, so msi-x won't
+	 * work. This causes a bug in RF-KILL flows, since the interrupt
+	 * that enables radio won't fire on the correct irq, and the
+	 * driver won't be able to handle the interrupt.
+	 * Configure the IVAR table again after reset.
+	 */
+	iwl_pcie_conf_msix_hw(trans_pcie);
+
+	/*
+	 * Upon stop, the APM issues an interrupt if HW RF kill is set.
+	 * This is a bug in certain verions of the hardware.
+	 * Certain devices also keep sending HW RF kill interrupt all
+	 * the time, unless the interrupt is ACKed even if the interrupt
+	 * should be masked. Re-ACK all the interrupts here.
+	 */
+	iwl_disable_interrupts(trans);
+
+	/* clear all status bits */
+	clear_bit(STATUS_SYNC_HCMD_ACTIVE, &trans->status);
+	clear_bit(STATUS_INT_ENABLED, &trans->status);
+	clear_bit(STATUS_TPOWER_PMI, &trans->status);
+	clear_bit(STATUS_RFKILL, &trans->status);
+
+	/*
+	 * Even if we stop the HW, we still want the RF kill
+	 * interrupt
+	 */
+	iwl_enable_rfkill_int(trans);
+
+	/*
+	 * Check again since the RF kill state may have changed while
+	 * all the interrupts were disabled, in this case we couldn't
+	 * receive the RF kill interrupt and update the state in the
+	 * op_mode.
+	 * Don't call the op_mode if the rkfill state hasn't changed.
+	 * This allows the op_mode to call stop_device from the rfkill
+	 * notification without endless recursion. Under very rare
+	 * circumstances, we might have a small recursion if the rfkill
+	 * state changed exactly now while we were called from stop_device.
+	 * This is very unlikely but can happen and is supported.
+	 */
+	hw_rfkill = iwl_is_rfkill_set(trans);
+	if (hw_rfkill)
+		set_bit(STATUS_RFKILL, &trans->status);
+	else
+		clear_bit(STATUS_RFKILL, &trans->status);
+	if (hw_rfkill != was_hw_rfkill)
+		iwl_trans_pcie_rf_kill(trans, hw_rfkill);
+
+	/* re-take ownership to prevent other users from stealing the device */
+	iwl_pcie_prepare_card_hw(trans);
+}
+
+void iwl_trans_pcie_gen2_stop_device(struct iwl_trans *trans, bool low_power)
+{
+	struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
+
+	mutex_lock(&trans_pcie->mutex);
+	_iwl_trans_pcie_gen2_stop_device(trans, low_power);
+	mutex_unlock(&trans_pcie->mutex);
+}
+
 static int iwl_pcie_gen2_nic_init(struct iwl_trans *trans)
 {
 	struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);

drivers/net/wireless/intel/iwlwifi/pcie/trans.c

@@ -80,7 +80,6 @@
 #include "iwl-prph.h"
 #include "iwl-scd.h"
 #include "iwl-agn-hw.h"
-#include "iwl-context-info.h"
 #include "iwl-fw-error-dump.h"
 #include "internal.h"
 #include "iwl-fh.h"
@@ -449,7 +448,7 @@ static void iwl_pcie_apm_lp_xtal_enable(struct iwl_trans *trans)
 				 ~SHR_APMG_XTAL_CFG_XTAL_ON_REQ);
 }
 
-static int iwl_pcie_apm_stop_master(struct iwl_trans *trans)
+int iwl_pcie_apm_stop_master(struct iwl_trans *trans)
 {
 	int ret = 0;
 
@@ -1126,7 +1125,7 @@ static void iwl_pcie_map_rx_causes(struct iwl_trans *trans)
 		iwl_write8(trans, CSR_MSIX_RX_IVAR(1), val);
 }
 
-static void iwl_pcie_conf_msix_hw(struct iwl_trans_pcie *trans_pcie)
+void iwl_pcie_conf_msix_hw(struct iwl_trans_pcie *trans_pcie)
 {
 	struct iwl_trans *trans = trans_pcie->trans;
 
@@ -1213,9 +1212,6 @@ static void _iwl_trans_pcie_stop_device(struct iwl_trans *trans, bool low_power)
 		}
 	}
 
-	iwl_pcie_ctxt_info_free_paging(trans);
-	iwl_pcie_ctxt_info_free(trans);
-
 	/* Make sure (redundant) we've released our request to stay awake */
 	iwl_clear_bit(trans, CSR_GP_CNTRL,
 		      CSR_GP_CNTRL_REG_FLAG_MAC_ACCESS_REQ);
@@ -1405,8 +1401,12 @@ void iwl_trans_pcie_rf_kill(struct iwl_trans *trans, bool state)
 
 	lockdep_assert_held(&trans_pcie->mutex);
 
-	if (iwl_op_mode_hw_rf_kill(trans->op_mode, state))
-		_iwl_trans_pcie_stop_device(trans, true);
+	if (iwl_op_mode_hw_rf_kill(trans->op_mode, state)) {
+		if (trans->cfg->gen2)
+			_iwl_trans_pcie_gen2_stop_device(trans, true);
+		else
+			_iwl_trans_pcie_stop_device(trans, true);
+	}
 }
 
 static void iwl_trans_pcie_d3_suspend(struct iwl_trans *trans, bool test,
@@ -2916,7 +2916,7 @@ static const struct iwl_trans_ops trans_ops_pcie_gen2 = {
 	.start_hw = iwl_trans_pcie_start_hw,
 	.fw_alive = iwl_trans_pcie_gen2_fw_alive,
 	.start_fw = iwl_trans_pcie_gen2_start_fw,
-	.stop_device = iwl_trans_pcie_stop_device,
+	.stop_device = iwl_trans_pcie_gen2_stop_device,
 
 	.send_cmd = iwl_trans_pcie_gen2_send_hcmd,