USB: Only treat lasting over-current conditions as errors

On a laptop I see these errors on (most) resumes:
    hub 3-0:1.0: over-current change on port 1
    hub 3-0:1.0: over-current change on port 2

Since over-current conditions can disappear quite quickly it's better to
downgrade that message to debug level, recheck for an over-current
condition a little later and only print and over-current condition error
if that condition (still) exists when it's rechecked.

Add similar logic to hub over-current changes. (That code is untested,
as those changes do not occur on this laptop.)
Signed-off-by: NPaul Bolle <pebolle@tiscali.nl>
Acked-by: NAlan Stern <stern@rowland.harvard.edu>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>

drivers/usb/core/hub.c

@@ -3408,12 +3408,19 @@ static void hub_events(void)
 			}
 			
 			if (portchange & USB_PORT_STAT_C_OVERCURRENT) {
-				dev_err (hub_dev,
-					"over-current change on port %d\n",
-					i);
+				u16 status = 0;
+				u16 unused;
+
+				dev_dbg(hub_dev, "over-current change on port "
+					"%d\n", i);
 				clear_port_feature(hdev, i,
 					USB_PORT_FEAT_C_OVER_CURRENT);
+				msleep(100);	/* Cool down */
 				hub_power_on(hub, true);
+				hub_port_status(hub, i, &status, &unused);
+				if (status & USB_PORT_STAT_OVERCURRENT)
+					dev_err(hub_dev, "over-current "
+						"condition on port %d\n", i);
 			}
 
 			if (portchange & USB_PORT_STAT_C_RESET) {
@@ -3445,10 +3452,17 @@ static void hub_events(void)
 					hub->limited_power = 0;
 			}
 			if (hubchange & HUB_CHANGE_OVERCURRENT) {
-				dev_dbg (hub_dev, "overcurrent change\n");
-				msleep(500);	/* Cool down */
+				u16 status = 0;
+				u16 unused;
+
+				dev_dbg(hub_dev, "over-current change\n");
 				clear_hub_feature(hdev, C_HUB_OVER_CURRENT);
+				msleep(500);	/* Cool down */
                         	hub_power_on(hub, true);
+				hub_hub_status(hub, &status, &unused);
+				if (status & HUB_STATUS_OVERCURRENT)
+					dev_err(hub_dev, "over-current "
+						"condition\n");
 			}
 		}