i40e: call clear_pxe after adminq is initialized

In the latest firmware the clear_pxe_mode function will use the
AdminQ request, so call this after AdminQ is set up rather than
relying on i40e_pf_reset() to clear the PXE mode.

Change-ID: Ice8cba2e9cbc3c7bde0a0bcf8eaf5009abef040b
Signed-off-by: NShannon Nelson <shannon.nelson@intel.com>
Signed-off-by: NJesse Brandeburg <jesse.brandeburg@intel.com>
Tested-by: NKavindya Deegala <kavindya.s.deegala@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/i40e/i40e_main.c

@@ -7612,6 +7612,7 @@ static int i40e_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
 		goto err_pf_reset;
 	}
 
+	i40e_clear_pxe_mode(hw);
 	err = i40e_get_capabilities(pf);
 	if (err)
 		goto err_adminq_setup;