PM / Domains: Set device state to "active" during system resume

The runtime PM status of devices in a power domain that is not
powered off in pm_genpd_complete() should be set to "active", because
those devices are operational at this point.  Some of them may not be
in use, though, so make pm_genpd_complete() call pm_runtime_idle()
in addition to pm_runtime_set_active() for each of them.
Signed-off-by: NRafael J. Wysocki <rjw@sisk.pl>

drivers/base/power/domain.c

@@ -786,7 +786,9 @@ static void pm_genpd_complete(struct device *dev)
 
 	if (run_complete) {
 		pm_generic_complete(dev);
+		pm_runtime_set_active(dev);
 		pm_runtime_enable(dev);
+		pm_runtime_idle(dev);
 	}
 }